Abstract:Abstract This paper aims at better understanding nanosecond sliding discharges based on a three-electrode geometry and at studying the effect of the shape of the pulsed high-voltage electrode on their electrical, optical and mechanical properties. Three different electrode shapes are considered: a typical planar electrode with a straight edge, a planar electrode with a sawtooth edge, and a wire electrode. First, we verified that the sliding discharge starts to appear when the potential difference between both air-exposed electrodes exceeds about 25 kV, corresponding to a mean electric strength (potential difference divided by the gap) a little bit higher than 6 kV cm −1 , but this value differs slightly depending on the shape of the electrode. Secondly, we highlighted that the current with the wire-based discharge is slightly higher compared to the two others because the streamers are more numerous and they are more uniformly distributed along the wire. Moreover, whatever the electrode shape, intensified charge-coupled device visualizations showed that many streamers initiate from the pulsed high-voltage electrode edge and propagate on the dielectric surface toward the DC voltage electrode at a mean velocity of about 1 mm ns −1 . However, the streamer trajectory depends strongly on the electrode shape. Visualizations of the pressure waves induced by the different plasma actuators have been realized with a shadowgraph system. In the presence of a sliding discharge, every streamer is at the origin of three different pressure waves. The first hemispherical pressure wave results from streamer ignition at the edge of the pulsed high-voltage electrode, the head of the streamer acting as a point heat source. The second hemispherical pressure wave is due to the corona-type discharge that ignites from the negative DC high-voltage electrode when the streamer head gets closer. Finally, the third wave is a semi-cylindrical wave as each streamer acts as a line source of heat. To conclude, pressure measurements highlighted that the peak value of the pressure is nearly constant along the spanwise direction of the wire electrode as it presents high fluctuations with the sawtooth electrode, the maximum pressure being measured above the tips, where streamers are localized.

Surface ionization wave propagation in the nanosecond pulsed surface dielectric barrier discharge: the influence of dielectric material and pulse repetition rate

Numerical simulation of streamer, pressure wave, and vortex induced by nanosecond pulsed surface dielectric barrier discharges

Investigation of positive and negative modes of nanosecond pulsed discharge in water and electrostriction model of initiation

Filamentary Surface Plasma Discharge Flow Length and Time Scales

Effect of Dielectric Barrier Discharge on Semiconductor Si Electrode Surface

Streamer propagation and pressure waves produced by a nanosecond pulsed surface sliding discharge: effect of the high-voltage electrode shape

Numerical Investigation on the Effect of Electrical Parameters on the Discharge Characteristics of NS-SDBD

Characteristics of annular surface dielectric barrier discharge with microsecond pulse under water-covered condition

Study on Underwater Nanosecond Surface Discharge Driven by Magnetic-switch-based Repetitive Pulsed Power Supply

Effect of the high voltage waveform on the ionic wind produced by a needle-to-plate dielectric barrier discharge

Counterflow Diffusion Flame Oscillations Induced by Ns Pulse Electric Discharge Waveforms

Spectroscopic Investigation of the Bipolar Pulsed Discharge in Water-Air Mixture

Streamer propagation dynamics in a nanosecondpulsed surface dielectric barrier discharge in He/N2mixtures

Experimental and 2D Fluid Simulation of a Negative Nanosecond Discharge in Air Above a Liquid Surface with Different Dielectric Permittivity and Electrical Conductivity

Investigation on the Shockwave Induced by Surface Arc Plasma in Quiescent Air

Streamer dynamics and charge self‐erasing of two counter‐propagating plasmas in repetitively pulsed surface dielectric barrier discharge

Investigation of the Microsecond-Pulse Acoustic Wave Generated by a Single Nanosecond-Pulse Discharge

Three-electrode surface dielectric barrier discharge driven by repetitive pulses: streamer dynamic evolution and discharge mode transition

Study of the electric field in a diffuse nanosecond positive ionization wave generated in a pin-to-plane geometry in atmospheric pressure air

Properties and characteristics of the nanosecond discharge developing at the water-air interface: tracking evolution from a diffused streamer to a spark filament

Characteristics of Unipolar Nanosecond Pulse DBD andIts Application on Surface Treatment of Polyimer Films