Abstract:The study of material properties relies on accurate and reliable testing instruments. Sensitively capturing changes in material performance is key to understanding the mechanisms of material properties. The Seebeck coefficient and resistivity testing instrument are essential for research on many functional materials. However, the current instrument is limited in its ability to capture sensitive changes due to testing principles. Here, we prepared three different types of non-equilibrium Zn 4 Sb 3 . We found that the existing static testing instrument has problems with testing interruption or inaccuracy when the sample undergoes chemical reactions, rapid atomic diffusion, or phase transitions. The cause of interruption is that the temperature control setting cannot meet the accuracy requirements of the testing instrument. The instrument's large temperature difference setting will cause the determination of the phase transition temperature to become inaccurate. To address the limitations, we have developed a dynamic testing instrument and tested the Seebeck coefficient and resistivity of Zn 4 Sb 3 and Ni in the range of 300 K–800 K. By ensuring the accuracy of each module of the instrument, optimizing the alternating temperature rise time, and improving the data acquisition calculation method, we have achieved accurate capture of sensitive performance changes in the non-equilibrium sample. Comparatively, dynamic testing reduces the measurement time by approximately 300 % compared to static testing. The standard deviation of measured Seebeck coefficient and resistivity is less than ±4 %. This study demonstrates that dynamic testing of the Seebeck coefficient and resistivity is an effective strategy for measuring non-equilibrium functional materials.

Precise Determination of the Thermal Conductivity of the Thermal Insulating Metal Material

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

A high-precision method to measure thermal conductivity of solids using reversible heat flux

A High-Precision Instrumentation of Measuring Thermal Contact Resistance Using Reversible Heat Flux

Measurement Techniques for Thermal Conductivity and Interfacial Thermal Conductance of Bulk and Thin Film Materials

Thermal Conductivity Measurement System for Functional and Structural Products

Instrument Design for Digital Thermal Conductivity Measurement.

A Micromachined Device Using Transient Hot-Wire Method For High Accuracy Thermal Conductivity Measurement Of Semi-Rigid Materials

Automatic Algorithm Applied for Calculating Thermal Conductivity by Transient Plane Source Method

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

An improved steady-state method for measuring the thermal contact resistance and bulk thermal conductivity of thin-walled materials having a sub-millimeter thickness

Numerical and Experimental Studies on the In-Situ Measurement of Thermal Conductivity of the Thermal Barrier Coating

Numerical Study of the Influence of Thermal Radiation on Measuring Semi-Transparent Thermal Insulation Material with Hot Wire Method

A Numerical Study on the Influence of Insulating Layer of the Hot Disk Sensor on the Thermal Conductivity Measuring Accuracy

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance

The Principle To Measure Thermal Conductivity By A New Thermal Probe Method

Measurement of non-equilibrium characteristics of thermoelectric materials

Automated system for measuring thermal conductivity of solid materials

An Experimental Investigation on Thermal Contact Resistance Across Metal Contact Interfaces

Thermal Conductivity Measurement of the Epoxies and Composite Material for Low Temperature Superconducting Magnet Design