Abstract:Mn0.5Mg0.5Fe2O4/Ba0.8Sr0.2Ti0.9Zr0.1O3 composite ceramics were prepared by sol-gel method and the effects of molar ratio (3:1, 2:1, 1:1, 1:2, 1:3) between the magnetic and ferroelectric phases on the microstructure, dielectric, ferroelectric and magnetic properties have been comparatively investigated. The results indicate that the obtained composite ceramics show bi-phase structure, without other apparent impurities. The surface is relatively uniform except for some pores, and the grain size of all the samples is near 1 μm. The dielectric constant shows decreasing trend with the molar ratio while the loss presents the opposite behavior. Only one relaxation peak can be observed when the molar ratio is less than 1:1, but two peaks are found when the molar ratio exceeds 1:1. The height of the peak decreases with the frequency and molar ratio while the position shifts to higher temperature range with the molar ratio. The dielectric loss increases sharply with the temperature and it is amounts to several thousand when the temperature is lager than 300 °C in the lower molar ratios. Both the resident polarization and coercive electric field increase with the measured voltage while they decrease with the frequency. The leakage current decreases with the molar ratio due to the lower conductivity of Mn0.5Mg0.5Fe2O4. The magnetization shows a monotonic variation behavior with the molar ratio, indicating the strong interface interaction between the two phases. The maximal ME coupling coefficient is about 800 mV/(cm.Oe) for the sample 3:1 due to the stronger magnetic properties.

Self-Assembled Batio3-Mnznfe2o4 Nanocomposite Films

Room Temperature Ferroelectric, Ferromagnetic and Magnetoelectric Properties of Ba-Doped Bifeo3 Thin Films

Electrical and magnetic properties of BaTiO3−(Ni0.3Zn0.7)Fe2.1O4 composites

Mechanism of Doping-Induced Orientation of Magnetic Phase in a Sol–Gel-Derived Ni0.5Zn0.5Fe2O4/BaTiO3 Multiferroic Thin Film with High Magnetoelectric Coupling

Magnetoelectric Cofe2o4-Pb(Zr0.52ti0.48)O-3 Composite Films Prepared By Pulsed-Laser Deposit Method

In Situ Formation of Composite Thin Film with (111) Oriented Ni0.5Zn0.5Fe2O4 Pillar Array Surrounded by BaTiO3 for Ferroelectric-Ferromagnetic Coupling

Anisotropy of Percolation Threshold of BaTiO3-Ni0.5Zn0.5Fe2O4 Composite Films

Magnetoelectric Effect in Multiferroic Heteroepitaxial BaTiO3–NiFe2O4 Composite Thin Films

Magnetoelectric Coupling Tailored by the Orientation of the Nanocrystals in Only One Component in Percolative Multiferroic Composites

Microstructure and Properties of Ni<sub>0.5</sub>Zn<sub>0.5</sub>Fe<sub>2</sub>O<sub>4</sub>-BaTiO<sub>3</sub> Ceramic

Growth and characterization of Bi 3.15 Nd 0.85 Ti 2.95 Hf 0.05 O 12 /La 0.67 Sr 0.33 MnO 3 composite film with strong magnetoelectric effect by chemical solution deposition under moderate crystallization temperature

Structure, Electrical, Optical and Magnetoelectric Properties of Magnetron Sputtered Nanocrystalline NiFe/BaTiO3 Thin Films

Ferroelectric, Dielectric, Ferromagnetic and Magnetoelectric Properties of the Multiferroic Heteroepitaxial NiFe 2 O 4 /ba 0.85 Ca 0.15 Ti 0.9 Zr 0.1 O 3 Composite Thin Films Deposited Via PLD

Microstructural, Electrical and Magnetic Properties of Multiferroic CoFe2O4/0.68Pb(Mg1/3Nb2/3)O3–0.32PbTiO3 Nanocomposite Thin Films

Study of electromagnetic properties of ferroelectric BaTiO3 and Mg0.2Cu0.2Zn0.6Fe1.94O4 composite materials

A comparative study of the dielectric, ferroelectric and anomalous magnetic properties of Mn0.5Mg0.5Fe2O4/Ba0.8Sr0.2Ti0.9Zr0.1O3 composite ceramics

Magnetic and magnetoelectric properties of as-deposited and annealed BaTiO<sub>3</sub>–CoFe<sub>2</sub>O<sub>4</sub>nanocomposite thin films

Investigation of Magnetic Properties of Ni0.2Cu0.2Zn0.6Fe1.96O4–BaTiO3 Composites

The Multiferroic Properties of (bi(0.9)ba(0.1))(fe(0.95)mn(0.05))o(3) Films

Multiferroic Batio3-Cofe2o4 Nano Composite Thin Films Grown By Polymer-Assisted Deposition

Preparation and Characterization of Self-Assembled Percolative BaTiO3-CoFe2O4 Nanocomposites Via Magnetron Co-Sputtering.