Abstract:Carbon nanotubes (CNTs) are quasi-1D nanostructures that display both high thermal conductivity and intriguing low-dimensional phonon transport phenomena. In comparison to the advances made in the theoretical calculation of the lattice thermal conductivity of CNTs, thermal transport measurements of CNTs have been limited by either the poor temperature sensitivity of Raman thermometry technique or the presence of contact thermal resistance errors in sensitive two-probe resistance thermometry measurements. Here we report advances in a multi-probe measurement of the intrinsic thermal conductivity of individual multi-walled CNT samples that are transferred from the growth substrate onto the measurement device. The sample-thermometer thermal interface resistance is directly measured by this multi-probe method and used to model the temperature distribution along the contacted sample segment. The detailed temperature profile helps to eliminate the contact thermal resistance error in the obtained thermal conductivity of the suspended sample segment. A differential electro-thermal bridge measurement method is established to enhance the signal-to-noise ratio and reduce the measurement uncertainty by over 40%. The obtained thermal resistances of multiple suspended segments of the same MWCNT sample increase linearly with increasing length, revealing diffusive phonon transport as a result of phonon-defect scattering in these MWCNTs. The measured thermal conductivity increases with temperature and reaches up to 390+- 20 W m-1 K-1 at room temperature for a 9-walled MWCNT. Theoretical analysis of the measurement results suggests submicron phonon mean free paths due to extrinsic phonon scattering by extended defects such as grain boundaries. The obtained thermal conductivity is decreased by a factor of 3 upon electron beam damage and surface contamination of the CNT sample.

In-Situ Heat Capacity Measurement of Carbon Nanotubes Using Suspended Microstructure-Based Microcalorimetry

Raman measurement of heat transfer in suspended individual carbon nanotube

Differential Multi-probe Thermal Transport Measurements of Multi-walled Carbon Nanotubes grown by Chemical Vapor Deposition

Catalyst-Free in Situ Carbon Nanotube Growth in Confined Space Via High Temperature Gradient

Quantitative Thermal Imaging of Single-Walled Carbon Nanotube Devices by Scanning Joule Expansion Microscopy.

Measurements of Thermal Conductivity of Individual Carbon Nanotubes

Thermal Characterization of Carbon Nanotube Fiber by Time-Domain Differential Raman

Study of Controlled Growth of Carbon Nanotubes in Microstructures at Low Temperature

Synthesis of Carbon Nanotubes on Suspending Microstructures by Rapid Local Laser Heating

Measurement of the intrinsic thermal conductivity of a multiwalled carbon nanotube and its contact thermal resistance with the substrate

Measuring the thermal conductivity of individual carbon nanotubes by the Raman shift method.

Thermal transport across the interface between a suspended single-walled carbon Nanotube and air

In situ measurements on individual thin carbon nanotubes using nanomanipulators inside a scanning electron microscope

Measuring the Thermal Conductivity of A Single Carbon Nanotube

Thermal conductivity characterization of three dimensional carbon nanotube network using freestanding sensor-based 3ω technique

Nanometer-level Temperature Mapping of Joule-heated Carbon Nanotubes by Plasmon Spectroscopy

Establishing Ohmic contacts for in situ current-voltage characteristic measurements on a carbon nanotube inside the scanning electron microscope.

Optical Absorptance Measurement Of An Individual Multiwall Carbon Nanotube Using A T Type Thermal Probe Method

Electrical measurement on individual multi-walled carbon nanotubes

Spatially-Resolved Temperature Measurements of Electrically-Heated Carbon Nanotubes

In Situ Synthesized Carbon Nanotube Networks on a Microcantilever for Sensitive Detection of Explosive Vapors