Abstract:In power system, it is important to obtain the instantaneous excitation characteristic of nonlinear inductive elements with magnetic cores such as power transformers, electromagnetic voltage transformers, reactors and so on, the instantaneous excitation characteristic influence electromagnetic transient phenomena. The direct testing method to acquire excitation characteristic is too complex to practice and the common method is that excitation characteristic is calculated according to effective volt-ampere characteristic, which is measured by applying voltage to the element. For theoretical research, analytical expression of excitation characteristic is necessary then a calculating method of the excitation characteristic of coil with iron core according to its volt-ampere characteristic is presented. In the paper, the instantaneous excitation characteristic is represented by a polynomial of the order thirteen with coefficients to be defined and the single-valued volt-ampere characteristic expression is obtained. With measured data, the volt-ampere characteristic can be acquired. The above-mentioned nonlinear curve-fitting problem is solved by the least-squares method and Levenberg-Marquardt method is used. The Levenberg-Marquardt method uses a search direction that is a cross between the Gauss-Newton direction and the steepest descent. The Gauss-Newton method is generally more effective when the residual is zero at the solution. However, such information is not always available beforehand, and the increased robustness of the Levenberg-Marquardt method compensates its occasional poorer efficiency. The main difficulty in the implementation of the Levenberg-Marquardt method is an effective strategy for controlling the size of scalar at each iteration so that it is efficient for a broad spectrum problems. The method used in this implementation is to estimate the relative nonlinearity of equation using a linear predicted sum of squares and a cubically interpolated estimate of the minimum. By a comparison with the calculated and experimental true saturation characteristic, it is observed that higher precision can be obtained especially in saturated regions, which is significant to study electromagnetic transient phenomena in power system.

Magnetization Curve Fitting of the Ignition Coil Core Based on Moving Least Squares

Characterizing Two-Stage Combustion Process in a Natural Gas Spark Ignition Engine Based on Multi-Wiebe Function Model

Analysis of Ignition Energy Efficiency for Automotive Ignition Coils

Effect Analysis of Ignition Energy Based on Automotive Ignition Coils Performance Simulation Model

Secondary Voltage Simulation Algorithm for Automotive Ignition System

Technological Parameters Modeling Method of Automotive Ignition Coils

Magnetizing Curve Identification for Induction Motors at Standstill Without Assumption of Analytical Curve Functions

A Novel Estimation Model for Hysteresis Loss Based on Semi-Minor Loops

Calculation Method for Excitation Characteristic of Coil with Iron Core

Parameters Estimation of Automotive Ignition Coils Based on Support Vector Regression

A Numerical Study into the Importance of Equivalence Ratio Measurement Accuracy for Spark Ignition Engines

Dynamic Characteristics of Moving-Magnet Linear Compressor Based on Finite Element Method

Online Identification of Inductance and Flux Linkage for SPMSMs Decoupled from Resistance Voltage Drop and VSI Nonlinearity

THE RELATION BETWEEN THE MISALIGNMENTS AND THE MEASURING ACCURACY OF THE ROTATING COIL MAGNETOMETER

Ignition coil primary current singularity detection algorithm

Magnetizing Curve Estimation of Induction Motors in Single-Phase Magnetization Mode Considering Differential Inductance Effect

Design of Programmable Sweep Signal Source used in Automotive Ignition Coil Misfire Detection

Inductance calculation for 3D microsolenoids with single-layer coils

An accurate real-time model of maglev planar motor based on compound Simpson numerical integration

Ignition Coil Insulation Fault Detection Algorithm.

Ignition coil insulation fault pulse classification algorithm