Abstract:The strain after rolling plays an important role in the prediction of the microstructure and properties and plate deformation permeability. So, it is necessary to establish a more accurate theoretical strain model for the rolling process. This paper studies the modeling method of the equivalent strain based on the upper bound principle and the stream function method. The rolling deformation region is divided into three zones (inlet rigid zone, plastic zone, and outlet rigid zone) according to the kinematics. The boundary conditions of adjacent deformation zones are modified according to the characteristics of each deformation zone. A near-real kinematics admissible velocity field is established by the stream function method on this basis. The geometric boundary conditions of the deformation region are obtained. The deformation power, friction power, and velocity discontinuous power are calculated according to the redefined geometric boundary conditions. On this basis, the generalized shear strain rate intensity is calculated according to the minimum energy principle. Finally, the equivalent strain model after rolling is obtained by integrating the generalized shear strain rate in time. The plate rolling experiments of AA1060 and the numerical simulations are carried out with different rolling reductions to verify the analytic model precision of the equivalent strain. The results show that the minimum and the maximum relative equivalent strain deviation between the analytic model and the experiment is 0.52% and 9.96%, respectively. The numerical calculation and experimental results show that the model can accurately calculate the strain along the plate thickness. This model can provide an important reference for the rolling process setup and the microstructure and properties prediction.

Correction and Application of Numerical Model on Plate Roller Levelling

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Numerical Modeling for Roller Leveling Process of Bimetal-Plate

Research on Leveling Model of Combination Leveler

FEM Simulation and Experimental Test on Residual Stress of Cold Expansion Hole of Rectangular Plate

Boundary Determination of Leveling Capacity for Plate Roller Leveler Based on Curvature Integration Method

Research on Force Simulation of Rolls' Deformation in the Rolling Process of Medium and Heavy Plate Leveler

A 2.5-Dimensional Analytical Model of Cold Leveling for Plates with Transverse Wave Defects

Research on Creation and Application of Material Models in the Rolling Process of Medium and Heavy Plate Leveler

Experiment and FEM Simulation on Residual Stress of Cold Expansion Hole

An Analytical Study of Optimal Roller Intermeshes for the Plate Leveling Process

A New Curvature Analytical Method in Plate Leveling Process

Numerical Analysis to Rolling Pressure Distribution of Plane View Pattern Controlling Pass of Plate Rolling

Numerical Simulation of Plate Rolling Process

Research on the Influence of Single Roll Adjusting to the Plate Straightening Quality

Design considerations in high strength plate leveler

An Analytical Leveling Model of Curvature and Residual Stress Simulation for H-beams

The central strain analytical modeling and analysis for the plate rolling process

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

The Effect of 1# Leveler Roller Intermesh to the Quality of the Plate

A Novel Modeling Method in Metal Strip Leveling Based on a Roll-Strip Unit