Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Predicting the vehicle induced building vibration by multi-source fuzzy dynamic analysis

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Vertical Vibration of Complex and Slender Footbridges Due to Stochastic Crowd-Induced Excitation

Environmental vibration induced by vehicle in complicated field

Vibration Reduction Analysis of an Old Residential District under Vehicle Load

Practical Back-Analysis Methodology to Predict Underground Train-Induced Building Vibrations

Structural dynamic and aerodynamic parameters identification for a tall building with full-scale measurements

Predicting Train-Induced Vibration of Building in Planning

The Transmission Characteristics and Influence Prediction of Impulsive Vibration Caused by a Solid Metal Ball Impact in Buildings

The analysis of building vibration induced by the road traffic

Peak Acceleration Response Spectrum of Long Span Floor Vibration by Pedestrian Excitation

VIBRATION COMFORT ANALYSIS AND DESIGN OF CONCRETE FLOOR BASED ON ANNOYANCE RATE

Predicting the Influence of Vibration from Trains in the Throat Area of a Metro Depot on Over-Track Buildings

Building Vibration Prediction Induced by Moving Train with Random Forest

The vibration measurement and analysis in the room of residential building caused by vehicles

Train-Induced Vibration and Structure-Borne Noise Measurement and Prediction of Low-Rise Building

VIBRATION ANALYSIS OF BASE-ISOLATED BUILDING NEAR URBAN RAIL TRANSIT

Prediction on wind‐induced responses for tall buildings considering frequency dependency of viscoelastic damped structures

The prediction of vehicle vibration transmitted to the occupant using a modular transfer matrix

Prediction and mitigation of train-induced vibrations of large-scale building constructed on subway tunnel

Subway‐induced floor vibration predictions in super high‐rise multi‐tower building located on over‐depot based on one‐dimensional impedance model