Abstract:Dissolution of carbonitrides and growth of austenite grain in X12CrMoWVNbN10-1-1 steel under various austenitizing conditions were investigated. The experimental results showed that the carbonitrides existing in after-forging heat treated state were mainly Cr23C6 and small amounts of NbN and Cr2N. However, Cr23C6 and Cr2N precipitates were dissolved completely after austenitization at 1070 degrees C for 60 min or at 1200 degrees C for 15 min, only the NbN particles left. The state of dissolution of NbN particles was also studied in detail as a function of austenitization holding time (t(A)) at different temperatures. Initially, the NbN particles dissolved with increasing t(A) at 1070 degrees C. When t(A) reached over 360 min, the amount of NbN remained approximately constant. On the contrary, during the process of austenitization at 1010 degrees C, no NbN particles dissolved into matrix. Starting from the fine and uniform grains, abnormal grain growth was observed after austenitizing at 1010 degrees C for 960 min or at 1070 degrees C for 180 min due to the heterogeneous distribution of NbN particles. The plot of grain size against t(A) indicated that the NbN particle with mean diameter of 117 nm and volume fraction of 3.1x10(-4) would be sufficient to inhibit the austenite grain size effectively. Finally, the EBSD measurements demonstrated that the high energy grain boundaries whose misorientation range is 20-45 degrees might be responsible for abnormal grain growth.

Novel process to refine grain size of NiCrMoV steel

Strain-induced Refinement and Thermal Stability of a Nanocrystalline Steel Produced by Surface Mechanical Attritiontreatment

Effective grain size refinement of an Fe-24Ni-0.3C metastable austenitic steel by a modified two-step cold rolling and annealing process utilizing the deformation-induced martensitic transformation and its reverse transformation

A NEW CYCLIC PHASE TRANSFORMATION TECHNOLOGY FOR GRAIN REFINEMENT OF 18ni(200) MARAGING STEEL

Modeling the Completely Recrystallized Grain Growth of NiCrMoV Rotor Steel

Optimization of Melt Treatment for Austenitic Steel Grain Refinement

Effects of grain refining on microstructure and properties of Fe-Ni-Mo-Cr maraging steel

New cyclic phase transformation technology for grain refinement of 18Ni maraging steel

Novel Method for Refinement of Retained Austenite in Micro/nano-Structured Bainitic Steels

Process Design and Heat Treatment Research of A Nitrogen-containing Cr-Ni Type Austenitic Stainless Steel

Grain Refinement and Delta Ferrite Reduction of High Cr Steel Ingots by Thermal Control

Carbonitride Dissolution And Austenite Grain Growth In A High Cr Ferritic Heat-Resistant Steel

Annealing Treatment Methods and Mechanisms for Refining Mixed and Coarse Grains in a Solution Treatment Nickel‐Based Superalloy

Influence of Thermomechanical Control Process on the Evolution of Austenite Grain Size in a Low-Carbon Nb-Ti-Bearing Bainitic Steel

Grain Refining of 409L Ferritic Stainless Steel Using Fe-Ti-N Master Alloy

A Novel Method and Mechanism for Simultaneously Refining Microstructure and Controlling Grain Orientation in Ti48Al2Cr2Nb2.5C Alloy

Solidification structure refining of 409L ferritic stainless steel using Fe-Ti-N master alloy

On the grain size refinement of TiAl alloys by cyclic heat treatment

Control of austenite grain size in a low carbon steel

Grain refinement of a Ti–47Al–8Nb–2Cr alloy through heat treatments

Notably Accelerated Nano-Bainite Transformation via Increasing Undissolved Carbides Content on GCr15Si1Mo Bearing Steel