Abstract:ZrB2-based 2-based ceramics typically necessitate high temperature and pressure for sintering, whereas ZrB2-SiC 2-SiC ceramics can be fabricated at 1500 degrees C using the process of reactive melt infiltration with Si. In comparison to the conventional preparation method, reactive synthesis allows for the more facile production of ultra-high temperature ceramics with fine particle size and homogeneous composition. In this work, ZrSi2, 2 , B4C, 4 C, and C were used as raw materials to prepare ZrB2-SiC 2-SiC via combination of tape casting and reactive melt infiltration herein referred to as ZBC ceramics. Control sample of ZrB2-SiC 2-SiC was also prepared using ZrB2 2 and SiC as raw materials through an identical process designated as ZS ceramics. Microscopic analysis of both ceramic groups revealed smaller and more uniformly distributed particles of the ZrB2 2 phase in ZBC ceramics compared to the larger particles in ZS ceramics. Both sets of ceramics underwent cyclic oxidation testing in the air at 1600 degrees C for a cumulative duration of 5 cycles, each cycle lasting 2 h. Analysis of the oxidation behavior showed that both ZBC ceramics and ZS ceramics developed a glassy SiO2-ZrO2 2-ZrO 2 oxide layer on their surfaces during the oxidation. This layer severed as a barrier against oxygen. In ZBC ceramics, ZrO2 2 is finely distributed in SiO2, 2 , whereas in ZS ceramics, larger ZrO2 2 particles coexist with glassy SiO2. 2 . The surface oxide layer of ZBC ceramics maintains a dense structure because the well-dispersed ZrO2 2 increases the viscosity of glassy SiO2, 2 , preventing its crystallization during the cooling. Conversely, some SiO2 2 in the oxide layer of ZS ceramics may crystallize and form a eutectic with ZrO2, 2 , leading to the formation of ZrSiO4. 4 . This leads to cracking of the oxide layer due to differences in thermal expansion coefficients, weakening its barrier effect. An analysis of the oxidation resistance shows that ZBC ceramics exhibit less increase in oxide layer thickness and mass compared to ZS ceramics, suggesting superior oxidation resistance of ZBC ceramics.

Oxidation Mechanism of ZrB2/SiC Ceramics Based on Phase-Field Model

Formation Mechanism and High Temperature Mechanical Property Characterization of Sic Depletion Layer in Zrb2/Sic Ceramics

Temperature-dependent oxidation kinetics and mechanical properties degradation of Cf/ZrB2-SiC composites

Oxidation Resistance Performance of ZrB_2-SiC Ceramic Matrix Composites

Oxidation behavior and phase transition of ZrB2-SiCw-ZrO2f ceramic

A Chemomechanical Coupling Model for Oxidation and Stress Evolution in ZrB2–SiC

Oxidation Behavior of ZrB2–SiC–ZrO2 Ceramic Composites in the Temperature Range of 800–1200°C

Design and Preparation of an Ultra-High Temperature Ceramic by In-Situ Introduction of Zr2[Al(Si)]4C5 into ZrB2-SiC: Investigation on the Mechanical Properties and Oxidation Behavior

PHASE-FIELD MODELING OF MOLTEN ZIRCONIUM OXIDATION COUPLED WITH FLOW AND HEAT TRANSPORT

Oxidation Behaviors of ZrB2–SiC Ceramics with Different Porosity

Oxidation Properties of ZrB2-20vol.%SiC-10vol.%BN Ceramic Composite at 1200°C

Oxidation Kinetics of Hot-Pressed ZrB2–SiC Ceramic Matrix Composites

Effect of atomic oxygen on oxidation behavior of ZrB2-SiC ceramic composite materials

Temperature-dependent Fracture Strength and the Effect of Oxidation for ZrB2-SiC Ceramics

Oxidation of ZrC-30vol% SiC composite in air from low to ultrahigh temperature

Oxidation Behaviour of C–SiC–ZrC Composite

Oxidation of Zirconium Diboride–silicon Carbide Ceramics under an Oxygen Partial Pressure of 200 Pa: Formation of Zircon

Microstructure and Oxidation Behavior of ZrB2-SiC 2-Sic Ceramics Fabricated by Tape Casting and Reactive Melt Infiltration

Characteristics and Mechanisms of Dynamic Oxidation for Zrb2-Sic Based Uhtc

Pursuing Enhanced Oxidation Resistance of ZrB2 Ceramics by SiC and WC Co-Doping

Oxidation Behaviors of ZrB2 Based Ultra-High Temperature Ceramics under Compressive Stress