Catalytic performance of Mn-promoted Ni/MgO catalysts in CO 2 reforming of toluene used as model compound of tar produced from biomass: Influence of preparation methods

Meng Kong
2012-01-01
Abstract:Catalytic performance of Mn-promoted Ni/MgO catalysts prepared using different methods was studied in CO 2 reforming of toluene. The catalyst preparation method influenced the catalytic performance. Over Ni/MgO catalyst without any promotes, the initial conversion of toluene can reach to 72.5% as compared with 37% when just MnO served as the support. For the Ni-MnO-MgO catalysts with Mn(NO 3) 2 as the precursor, the conversions of toluene were no more than 20%, among them, Ni/MnO-MgO-PI had a relatively higher activity with 22.5% of toluene converted at initial time, but it decreased quickly to < 10% after 5 hr test. Using MnO 2 as the precursor, the highest and stable performance with 81% of toluene converted can be obtained over Ni/Mn-MgO-MI catalyst. For Ni-MnO-MgO with Mn(NO 3) 2 as the precursor, thetotal conversion of toluene were no more than 10%,including 1.5-2.5% of toluene was converted into benzene. The proportion for toluene to benzene was 0.8% over Ni/MgO and 0.4% over Ni/Mn-MgO-MI; it can be considered that the existence of Mn promotes the conversion of toluene. This is an abstract of a paper presented at the 2012 AIChE Spring Meeting and 8th Global Congress on Process Safety (Houston, TX 4/1-5/2012).
What problem does this paper attempt to address?