Fault Location for Distribution Network Based on Fault Distance Distribution Function

TAN Dan,YANG Honggeng,QU Guanglong

DOI: https://doi.org/10.13335/j.1000-3673.pst.2012.10.025

2012-01-01

Abstract:Based on bus voltage sag characteristics and fault distance distribution function,a single terminal fault location algorithm for distribution network was proposed to improve the accuracy of fault location.The fault distance distribution function was established by nodal impedance matrix that reflected the variation of fault distance,and according to fault distance distribution function and the post-fault voltage sag data measured at the terminal located in substation the fault distance was calculated,and through data matching and stepwise approximation the transition resistance was determined and a sorting algorithm was led in to sort all possible fault points,thus the affect of pseudo-fault points on fault location result could be reduced.The proposed method was suitable for fault location of three-phase unbalanced distribution network and the iteration of short-circuit calculation was not needed.Simulation results of a neutral point unearthed distribution network showed that the proposed method was effective.