Abstract:The converter controller model is the key part of a doubly-fed induction generator (DFIG) model.Because of the large number of controller parameters and the series connection between the PI controllers of inner and outer control loops,the traditional identification methods have some trouble with identifiability or engineering realization.A parameter identification method is proposed based on the disturbances made on the measurement signals of secondary side,which features multi-step identification and interactive iteration.The method separately makes disturbances on the measurement signals which are used as input of PI controllers in the converter control system.These disturbances can enlarge the effect of the triggered PI controller on the response of a DFIG.Therefore,parameters of the triggered PI controller can be identified by using its measurable control target as the observation.For the series connected PI controllers,the measurement signal disturbance will be made on the latter PI controller while shielding the change of the input measurement signal of the former PI controller. Thus,the decoupling identification can be carried out on the parameters of series connected PI controllers.Using the proposed method,the two parameters of each PI controller in the converter control system can be identified separately without any identifiability problem under the certain measurement signal disturbance.And the interactive iteration of identification can further improve the identification accuracy of total parameters.

Key Issues of Synchronous Generator Parameter Identification Using PMU Measurements

System Wide Parameter Identification of Multi-generators in Power Systems

A study on the identifiability of synchronous generator parameters

Identification of synchronous generator practical parameters based on time interval

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Three Analysis of Several Important Issues

Parameter Identification Method for Converter Controller of DFIG Based on Measurement Signal Disturbance

Observed Variables Selection for Parameter Identification of Multi-Generators in Power Systems

Probabilistic Preassessment Method of Parameter Identification Accuracy with an Application to Identify the Drive Train Parameters of DFIG

Parameter Identification of Phase-Locked Loop in DFIG-Based Wind Turbine

A Two-step Method for Estimating DFIG Parameters in a Wind Turbine and the Measurement Selection

Model parameter identification of DFIG based on short circuit current

Parameter identification of drive system for fixed-speed wind power generation units

Mechanical Parameter Identification of Synchronous Water Turbine Generator Unit

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Multi-scenario parallel interior algorithm for generator parameter identification in power systems

Identification and Validation for Synchronous Generator Parameters Based on Recorded On-Line Disturbance Data

PMU Based Problematic Parameter Identification Approach for Calibrating Generating Unit Models

Generator Available Inertia Estimation Based on Various Disturbance Measurements of PMU

Optimal PMU Placement Approach for Power Systems Considering Non-Gaussian Measurement Noise Statistics

Least Squares Estimation-Based Synchronous Generator Parameter Estimation Using PMU Data

Transmission Lines Positive Sequence Parameters Estimation and Instrument Transformers Calibration Based on PMU Measurement Error Model