Abstract:We focus on the parameter identification of doubly fed induction generator （DFIG} based wind turbine generator （WTG）. Firstly, the trajectory sensitivity analysis is used to make judgments about the identifiability of parameters. If the phases of sensitivity curves are not the same or reverse, the parameters are uniquely identifiable. By this theory, we find that the stator reactance and rotor reactance cannot be simultaneously identified, but the other parameters are uniquely identifiable. Secondly, the difficulty of identification which means the possibility of obtaining the accurate values o{ the parameters from the measurement data is analyzed. A parameter is easy to be identified if the sensitivities of both time-domain and frequency-domain are high. A parameter which has a high value only in the low frequency area of the frequency-domain sensitivity curve is relatively easy to be identified. It is found that the stator reactance, rotor reactance, and exciting reactance are easy to be identified; the stator resistance and rotor resistance are relatively easy to he identified; the inertial constant is difficult to be identified. According to the analysis of identifiability and the difficulty of identification, four key parameters including the stator resistance, stator reactance, exciting reactance, and rotor resistance are decided to be identified. Then, an ant colony optimization algorithm based identification method is designed. Finally, the correctness of the analysis and the efficiency of the identification method are validated by the simulation results obtained in Matlab/Simulink environment.

Mechanical Parameter Identification of Synchronous Water Turbine Generator Unit

A study on the identifiability of synchronous generator parameters

Parameter identification of drive system for fixed-speed wind power generation units

Model parameter identification of DFIG based on short circuit current

Identification of synchronous generator practical parameters based on time interval

Analysis on the Identification of Doubly Fed Induction Generator

Probabilistic Preassessment Method of Parameter Identification Accuracy with an Application to Identify the Drive Train Parameters of DFIG

Parameter Estimation of Drive System in A Fixed-Speed Wind Turbine by Utilising Turbulence Excitations

Parameter identification of three-mass drive-train system for fixed-speed wind turbine generator based on PSO algorithm

System Wide Parameter Identification of Multi-generators in Power Systems

Recursive Least Square Method Based Parameter Identification of Steam Turbine Digital Electric-Hydraulic Governing System

The Parameter Identification Method of Steam Turbine Nonlinear Servo System Based on Artificial Neural Network

Parameter Identification of Induction Motors for Railway Traction Applications

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Study on identification method for parameter uncertain model of aero gas turbine

Parameter Identification Of Inverter-Fed Induction Motors: A Review

DYNAMIC PARAMETER IDENTIFICATION OF THE STEAM TURBINE-GENERATOR BY LOAD REJECTION TEST USING DYNAMOMETRY METHOD

Parameter Identification Considering Inverter Nonlinearity and Iron Loss for PMSM

Study on Modelling and Parameter Identification of Hydro Turbine and Governor System

A Controller Parameter Identification Method of PMSG-Based Wind Turbine Generator Based on Measured Impedance

STUDY ON PARAMETER IDENTIFICATION FOR STEAM TURBINE DHE GOVERNING SYSTEM BASED ON GENETIC ALGORITHM