Abstract:We focus on the parameter identification of doubly fed induction generator （DFIG} based wind turbine generator （WTG）. Firstly, the trajectory sensitivity analysis is used to make judgments about the identifiability of parameters. If the phases of sensitivity curves are not the same or reverse, the parameters are uniquely identifiable. By this theory, we find that the stator reactance and rotor reactance cannot be simultaneously identified, but the other parameters are uniquely identifiable. Secondly, the difficulty of identification which means the possibility of obtaining the accurate values o{ the parameters from the measurement data is analyzed. A parameter is easy to be identified if the sensitivities of both time-domain and frequency-domain are high. A parameter which has a high value only in the low frequency area of the frequency-domain sensitivity curve is relatively easy to be identified. It is found that the stator reactance, rotor reactance, and exciting reactance are easy to be identified; the stator resistance and rotor resistance are relatively easy to he identified; the inertial constant is difficult to be identified. According to the analysis of identifiability and the difficulty of identification, four key parameters including the stator resistance, stator reactance, exciting reactance, and rotor resistance are decided to be identified. Then, an ant colony optimization algorithm based identification method is designed. Finally, the correctness of the analysis and the efficiency of the identification method are validated by the simulation results obtained in Matlab/Simulink environment.

Analysis on the Identification of Doubly Fed Induction Generator

Parameter Identification of Phase-Locked Loop in DFIG-Based Wind Turbine

Model parameter identification of DFIG based on short circuit current

Parameter identification of drive system for fixed-speed wind power generation units

Parameter Identification Method for Converter Controller of DFIG Based on Measurement Signal Disturbance

Online Identification of Static Characteristic Coefficients of Wind Farm Based on Small Disturbances

Optimized design of resonant controller for stator current harmonic compensation in DFIG wind turbine systems

Identification of DFIG parameters based on improved PSO algorithm

Decoupling Estimation of Parameters in Rotor Side Controller of DFIG-based Wind Turbine by Frequency Domain Method

Distinguishability Analysis of Controller Parameters with Applications to DFIG Based Wind Turbine

Modeling and Control of Wind Turbine with Doubly Fed Induction Generator

Hierarchical Parameter Estimation of DFIG and Drive Train System in a Wind Turbine Generator

Stator Fault Detection Of Doubly-Fed Induction Generators Using Rotor Instantaneous Power Spectrum

Phase–amplitude Model for Doubly Fed Induction Generators

Parameter Tuning of Doubly Fed Induction Generator Systems for Wind Turbines Based on Orthogonal Design and Particle Swarm Optimization

Parameter Identification of DFIG Converter Control System Based on WOA

Improved identification method of doubly-fed induction generator based on trajectory sensitivity analysis

Simulation of a Site-Specific Doubly-Fed Induction Generator (DFIG) for Wind Turbine Applications

Parameter Identification of Doubly-Fed Induction Generator by the Levenberg-Marquardt-Fletcher Method

An Identification Method for Sequence Impedance Model of DFIG Based on the Joint of Knowledge Driving and Data Driving

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System