Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Suppression of UHF partial discharge signals buried in white-noise interference based on block thresholding spatial correlation combinative de-noising method

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

An Automatic Tool for Partial Discharge De-Noising via Short-Time Fourier Transform and Matrix Factorization

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Analysis and Denoising of Electric Noise in Phased Array Ultrasonic Testing System

Enhanced Noise Suppression in Partial Discharge Signals via SVD and VMD with Wavelet Thresholding

Analysis and Rejection of Noises from Partial Discharge (PD) On-Site Testing Environment

Uhf Signal Processing and Pattern Recognition of Partial Discharge in Gas-Insulated Switchgear Using Chromatic Methodology

Detection and Identification Technologies of Wide Band Partial Discharge

Noise Reduction of Partial Discharge in Power Cable Insulation Based on Deep Learning

On-line PD Data Analysis and Interference Suppression by Software

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Comparison of Different Time-Frequency Analysis Methods for Sparse Representation of PD-induced UHF Signal

Passive Wireless Partial Discharge Sensors with Multiple Resonances

Extracting Partial Discharge Signals Using AGR

A Novel Hybrid Approach for Partial Discharge Signal Detection Based on Complete Ensemble Empirical Mode Decomposition with Adaptive Noise and Approximate Entropy

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

The Denoising Method for Transformer Partial Discharge Based on the Whale VMD Algorithm Combined with Adaptive Filtering and Wavelet Thresholding

A Novel De-Noising Method Based on Coherence Average for Ultrasonic Signal of Partial Discharge in Transformer

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS