Abstract:During the operation progress of solid oxide fuel cell (SOFC), the performance and endurance are two major concerns significantly affected by gas flowing, charge transport, and chemical reaction. This paper presents a thorough research on the key parameters related to syngas and charge transport in the SOFC to reveal the intrinsic influence mechanism, including electro conductibility, gas mixture concentration, CH 4 component ratio, temperature, and anode thickness, which is instrumental in improving the operational efficiency and applicability of SOFC. Firstly, the theoretical models of charge transport and multi-component mass transfer are established, respectively, and the two are coupled using the reaction rate calculation method. Then, employing an innovative combination of the representative elementary volume (REV) scale lattice Boltzmann method (LBM) and the finite-difference LBM, the potential and multi-component gases distributions are simulated to calculate the evaluated indicators, namely activation and concentration overpotential. Finally, considering various operational conditions, the simulation experiments are conducted to investigate the parametric effect on the performance of SOFC fueled by syngas. The results demonstrate that compared to the direct reforming way, the external syngas with lower CH 4 component ratio is more favorable to the SOFC and the optimal ratio should be controlled within 0.2. The higher concentration of gas mixture and lower anode thickness both contribute to weakening the effect of concentration polarization. Especially, the performance of SOFC is improved when the concentration is 15 mol‧m −3 and the anode thickness is below 1.05 mm. With the increment of conductivity and operating temperature, the consumption of H 2 gradually increases, enhancing the efficiency of reaction gas and reducing the economic cost. And the optimal operation temperature of SOFC is about 1073 K. Moreover, the anode thickness is a trade-off between the electrochemical reaction conditions of anode and cathode, as its variation affects both of them.

Numerical Analysis of the Possibility of Carbon Formation in Planar SOFC Fueled with Syngas

Effects of Syngas Components on the Carbon Formation in Planar Solid Oxide Fuel Cell

Numerical investigation of different loads effect on the performance of planar electrode supported SOFC with syngas as fuel

Numerical simulation of carbon deposition in solid oxide fuel cells

Experimental Study of the Carbon Deposition from CH4 Onto the Ni/YSZ Anode of SOFCs

Effects of Coal Syngas Major Compositions on Ni/Ysz Anode-Supported Solid Oxide Fuel Cells

Numerical Study on Carbon Deposition of SOFC with Unsteady State Variation of Porosity

Numerical research on carbon activity, fuel utilization, chemical reaction, and temperature distribution for IT single planar SOFC

Microstructure, Performance And Stability Of Ni/Al2o3 Cermet-Supported Sofc Operating With Coal-Based Syngas Produced Using Supercritical Water

Parametric analysis of solid oxide fuel cell fueled by syngas based on lattice Boltzmann method

Controlled Deposition and Utilization of Carbon on Ni-Ysz Anodes of Sofcs Operating on Dry Methane

Performance of Planar Electrode Supported Solid Oxide Fuel Cell With Syngas as Fuel

Experimental and Modeling Study of High Performance Direct Carbon Solid Oxide Fuel Cell with in Situ Catalytic Steam-Carbon Gasification Reaction

Numerical Simulation of Fluidized Bed Gasifier Coupled with Solid Oxide Fuel Cell Fed with Solid Carbon

Impact of SOFC anode carbon deposition and hydrogen adsorption on the cell performance by molecular simulation

Numerical investigation of the chemical and electrochemical characteristics of planar solid oxide fuel cell with direct internal reforming

Investigation of Carbon Formation on Ni/YSZ Anode of Solid Oxide Fuel Cell from CO Disproportionation Reaction

System Simulation and Parametric Analysis of Low-Concentration Coal Mine Gas Fed SOFC-CHP with Deoxygenation and Enrichment Pretreatment

Performance and Stress Analysis of Flat-Tubular Solid Oxide Fuel Cells Fueled with Methane and Hydrogen

Electrochemical Characteristics and Carbon Tolerance of Solid Oxide Fuel Cells with Direct Internal Dry Reforming of Methane

Numerical study on the impact of carbon deposition on methane/steam mass transport in solid oxide fuel cell porous anode using lattice Boltzmann modeling