Abstract:Activation is a crucial procedure to improve the performance of newly fabricated fuel cell stacks to meet the power requirements in actual application scenarios. However, traditional activation procedures generally last for several hours or even days, which greatly increases the cost and limits the production efficiency. In response to this problem, this paper proposes a rapid activation procedure composed of hydrogen pumping (HP) and limiting-current activation with limited air (LCA). The influence of current density for HP and air supply for LCA on activation effect is studied and the best operating conditions are determined. The importance of water supply to the cathode is highlighted during HP. The influence of air supply for LCA on activation effect is limited, which contributes to gas saving. According to the experiments conducted on a single cell and a 10-cell stack, only 40 min are needed with this combined procedure, which is much shorter than that of the traditional step-current activation. Furthermore, nearly 75% of hydrogen is saved due to the short activation time and the control of gas supply, thus significantly reducing the cost during activation. Furthermore, to reveal the underlying mechanisms, membrane electrode assembly parameters before and after activation are obtained by micro-current excitation. A decrease in ohmic resistance and an increase in roughness factor of catalyst are observed, which contribute to performance improvement. According to the characterizations in the microstructure of membrane electrode assembly and platinum catalyst valence state, the electrolyte hydration and oxide reduction are determined as key factors and principles during activation.

A Three-Step Activation Method for Proton Exchange Membrane Fuel Cells

Disclosure of the Internal Mechanism During Activating a Proton Exchange Membrane Fuel Cell Based on the Three-Step Activation Method

Optimization of the activation condition of a PEM fuel cell for automotive

Rapid activation of proton exchange membrane fuel cell stack and underlying mechanisms involved

Activation of polymer electrolyte membrane fuel cells: Mechanisms, procedures, and evaluation

Initial research on the activation process for a PEMFC: Phenomenon analysis

Activation Methods and Underlying Performance Boosting Mechanisms Within Fuel Cell Catalyst Layer

Introducing Catalyst in Alkaline Membrane for Improved Performance Direct Borohydride Fuel Cells

The Performance Improvement of Membrane and Electrode Assembly in Open-Cathode Proton Exchange Membrane Fuel Cell

Balancing proton and mass transfers in cathode catalyst layer of high-temperature proton exchange membrane fuel cell via gradient porous structure design

Study of optimal step-wise distributions of platinum and carbon loading in cathode catalyst layer of a proton exchange membrane fuel cell

Rapid activation of a full-length proton exchange membrane fuel cell stack with a novel intermittent oxygen starvation method

Alteration of the Membrane Electrode Assemblies during Direct Methanol Fuel Cell Activation Process

The Recovery Mechanism of Proton Exchange Membrane Fuel Cell in Micro-Current Operation

Pt/C Modified Proton Exchange Membrane for Improved Fuel Cell Performance

Nanoimprint of Proton Exchange Membrane for MEMS-based Fuel Cell Application

Electrocatalysis for Proton Exchange Membrane Fuel Cells

Study on counter-flow mass transfer characteristics and performance optimization of commercial large-scale proton exchange membrane fuel cells

Optimization of Membrane Electrode Assembly of PEM Fuel Cell by Response Surface Method

Patterned Catalyst Layer Boosts the Performance of Proton Exchange Membrane Fuel Cells by Optimizing Water Management

Recent Advances in Pt Catalysts and Membrane Electrode Assemblies Fabrication for Proton Exchange Membrane Fuel Cells