Abstract:The fiber optic gyroscope (FOG) is an angular rate sensor based on Sagnac effect. It has been widely used in aviation, unmanned, robot, and other fields due to its benefits of all solid state, high precision, and low cost. However, the photoelectric devices inside the FOG will produce a non-negligible error in the dynamic environment, resulting in zero bias drift and increased noise. Currently, research on the dynamic error of FOG focuses primarily on linear vibration, assuming that no input angular rate exists at this moment. However, the dynamic errors caused by angular vibration are more complicated in the practical application environment. The output of FOG includes both effective angular information and dynamic error at this moment, which means that the dynamic error should be removed while the effective angular information must be retained. In this paper, we focus on the effect of angular vibration on FOG, and propose a dynamic error compensation method of FOG based on complete ensemble empirical mode decomposition with adaptive noise (CEEMDAN) that properly separates the effective signal and dynamic error. We also consider the amplitude frequency characteristics of FOG under dynamic conditions and utilize the FOG bandwidth test experiment to verify the effectiveness of our method. The experimental results show that the compensated signal can correctly calculate the bandwidth of FOG. It indicates that our method can effectively compensate the dynamic error in angular vibration environment while improving the performance of FOG in dynamic environment.

Optimize and analysis of fiber optic gyroscope combination bracket based on redundancy design

Principle and Application of High Dynamic Fiber Gyroscope

Research on Dynamic Performance Evaluation of Fiber Optic Gyroscope Based on Laser Doppler Measurement Technology

Theory And Error Compensation Method Based On The Tilt Sensor Adopted In Dynamic Angle Measurement Of The Fiber Optic Gyroscope

Uncertainty Analysis of Dynamic Goniometer Based on Fiber Optic Gyroscope

Analysis of Fiber Optic Gyroscope Dynamic Error Based on CEEMDAN

Measurement and analysis about the strain of fiber opitical loop

Research on testing technology based on three-axis diagonal integration of fiber-optic gyro

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

Structure Design and Structural Parameter Optimization of Fully Symmetric Vibratory Gyroscope

Reliability analysis of spherical six axis redundant inertial measurement unit

A Novel Modal Analysis Method on Fiber Optical Gyroscope Fixture

Improving the Performance of Broadband Source-Driven Resonant Fiber-Optic Gyroscopes

Design and Test of Prototype Attitude Control System As Telescope Stabilizer with Fiber Optic Gyroscopes

Balance Orthogonal Demodulation with Combined Adaptive Optimization for Interferometric Fiber Optic Gyroscopes

Performance Improvement of a Resonant Fiber Optic Gyroscope with a Hybrid Photonic Crystal Fiber Ring Resonator.

Thermal Design and Analysis for Fiber Optic Gyroscope Combination

Reducing Polarization-Fluctuation Induced Drift in Resonant Fiber Optic Gyro by Using Single-Polarization Fiber.

Revised Minimum Reciprocity Configuration and Actualization Methodology of Interferometric All-Fiber-Optic Gyroscopes

Close loop fiber optic gyroscope with hybrid structure

A Multiplexing Fiber Optic Gyro