Abstract:Interpretation of the temperature dependence of the dynamic yield stress of shock-loaded metals has recently become a critical problem in shock wave physics. However, the temperature dependence of the dynamic yield stress of BCC metals is rarely investigated owing to the lack of an accurate description of the constitutive behavior of BCC metals subjected to high strain rate and high temperature. To unravel the underlying mechanism of the dynamic yield stress of BCC metals under such extreme conditions, we established a dislocation-based constitutive model in which the dislocation generation equation is proposed from the viewpoint of dissipation energy. When applied to shock-loaded BCC metals, this model reproduced the elastic-plastic wave characteristics observed in preheated plate-impact experiments quantitatively even at temperatures of > 1000 K. It was found that forest hardening induced by thermally activated homogeneous nucleation (TA-HN) serves as the primary contributing factor to the thermal hardening behavior of vanadium at elevated temperature, while Peierls stress serves as the primary contributing factor to the thermal softening behaviors of other BCC metals. The novelty of this work lies in that the forest hardening mechanism, as a plastic hardening mechanism and usually regarded as temperature insensitive for BCC metals, has been proved to be temperature sensitive and influence dislocation motion significantly owing to TA-HN at high strain rate and high temperature. Based on this mechanism, we also predicted that the thermal hardening behavior would also occur in other BCC metals, e.g., molybdenum and tungsten, at temperature ranges beyond the limit of existing experiments.

A Review of Plastic Flow Characteristic and Constitutive Mode of Several Typical BCC Metals

PLASTIC FLOW STRESSES AND CONSTITUTIVE MODELS OF FOUR NEWER NAVAL VESSEL STEELS

The Plastic Flow Behavior and Model of Bcc Polycrystalline Metals with Application to Pure Ta, Mo, Nb and V

The Characteristics of Plastic Flow and a Physically-Based Model for 3003 Al–Mn Alloy Upon a Wide Range of Strain Rates and Temperatures

A physically-based constitutive model for BCC metals and its application in tantalum

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

PLASTIC FLOW CHARACTERISTICS AND CONSTITUTIVE RELATION FOR ULTRA HIGH STRENGTH STEEL AF1410

Plastic flow characteristics and constitutive relation of ultra high strength steel 18Ni250

Plastic Flow Characteristics and Physically‐based Constitutive Modelling of Commercially Pure Vanadium

Plastic Behavior and Constitutive Relations of DH-36 Steel over a Wide Spectrum of Strain Rates and Temperatures under Tension

Tensile plasticity flow characteristics of DH36 steel and its constitutive relation

Constitutive Modelling of Plasticity of Fcc Metals under Extremely High Strain Rates

Experimental and Physical-Based Constitutive Model Study of Fcc Metal over Wide Temperature and Strain Rate Ranges

Dislocation Density-Based Model for Flow Behavior of a Near-α Titanium Alloy Considering Effects of Initial Lamellar Thickness

Plastic Flow Characteristics and Physical Conception Constitutive Relation for AZ31 Cast Magnesium Alloy

Flow behavior and semi-empirical constitutive model of TC11 titanium alloy

Strain Rate Sensitivity and Constitutive Models of Several Typical Aluminum Alloys

Numerical Investigation of the Temperature Dependence of Dynamic Yield Stress of Typical BCC Metals under Shock Loading with a Dislocation-Based Constitutive Model

Comparison of Constitutive Models for Fcc Metals over Wide Temperature and Strain Rate Ranges with Application to Pure Copper

Constitutive Analysis on High-Temperature Flow Behavior of 3Cr-1Si-1ni Ultra-High Strength Steel for Modeling of Flow Stress

Plastic Flow Modeling of Ti-5Al-2Sn-2Zr-4Mo-4Cr Alloy at Elevated Temperatures and High Strain Rates