Abstract:Owing to the presence of joint resistance and flux creep, high-temperature superconducting (HTS) coils without a power supply inevitably suffer from current decay. A flux pump is a voltage supply that requires connections with smaller footprints and a lower heat load than traditional current leads. In this study, we explain the principle of the upper limit for the output current of the traveling wave flux pumps. Based on this principle, a miniaturized linear flux pump device was developed. With narrow and misaligned iron teeth, elaborate 3D geometry of the iron pieces, and optimized driving current waveform, the miniaturized flux pump can support more than 120 A output current with only a 10 mm wide HTS tape and a compact size of 4.6 x 4.6 x 3.4 cm. Our experimental results show that the critical current of the HTS tape has a significant effect on the flux pump output. An HTS tape with a larger critical current supports a higher maximum transport current, whereas an HTS tape with a smaller critical current requires less applied current for positive output. Finally, excitation tests on HTS coils were performed. Charge/active discharge and field supplement experiments were done on a maglev HTS racetrack coil of 0.4 H, where charging/field supplement capability of the miniaturized flux pump were demonstrated up to 46.8 A (close to the critical current of the coil). It has also been proved that the flux pump can work together with an external power supply with persistent current switch. The miniaturized flux pump can also independently charge an HTS coil of 60 & mu;H to 91.6 A, which is the critical current of the coil at a low voltage criterion.

Method to judge current capacity of HTS tapes in 50Hz AC condition

Optimization Configuration of High Voltage Reactors in Large Power Grid

Development of a Conduction-Cooled HTS SMES

General Design of a 300-Kvar HTS Synchronous Condenser Prototype

An Optimize Design of HTS Transformer:Multi-Width and Multi-Distance Structure

Stepped-shape Field Winding Optimization of a Large Capacity HTS Aircraft Propulsion Machine

Development and Testing of a 300-Kvar HTS Synchronous Condenser Prototype

Detection and Analysis of Fault for HTS AMDT Cores by Magnetostriction-Induced Vibration

HTS dc bias coil for 35 kV/90 MVA saturated iron-core fault current limiter

Numerical Study on Transient Behaviours of a 30-kW Generator Using a Coupling Method

A Practical Superconducting DC Dynamo for Charging Conduction-Cooled HTS Magnet

Electromagnetic Design of HTS D-shaped Coils for a Toroidal-type Superconducting Magnet

Thermal Analysis for the Hts Stator Consisting of Hts Armature Windings and an Iron Core for A 2.5 Kw Hts Generator

Over-Current Simulation Test for High Temperature Superconducting Generator

Modelling and Analysis on AC Loss of HTS Tapes with Magnetic Substrate under Harmonic Current in Power Systems

Study of 16ka High Temperature Superconducting Current Leads Used in EAST's Toroidal Field Magnets System

Miniaturized HTS linear flux pump with a charging capability of 120 A

An Experimental Investigation of Critical Current and Current Distribution Behavior of Parallel Placed HTS Tapes

Research on the Characteristics of a High-temperature Superconducting Leakage Flux-controlled Reactor

Novel Test Method for AC Current-Carrying Capability in the Consideration of Alternating Magnetic Field

The High Voltage Problem In The Saturated Core Hts Fault Current Limiterk