Abstract:This study proposes two atomic force microscope (AFM) tip-based direct nanoscratching methods including single-pass scratching and multi-pass scratching compared with a vibration-assisted scratching method to fabricate nano-grooves on the surface of the polymethylmethacrylate (PMMA) thin-film resist. In order to protect the AFM tip from wearing and optimize the subsequent etching process, the machined depth is expected slightly less than the PMMA thickness to prevent the tip directly contacting with the silicon substrate and obtain better process results. First, single-pass scratching tests are performed on films with different thickness employing varied normal loads. Results show that the machined depths of the grooves cannot be obtained slightly less than the thickness of the film very easily when scratching with single-pass method, 50-120 nm in the present study, which may not be very suitable for the following etching process. Multi-pass and vibration-assisted methods are then utilized to solve this limitation of the machined depth in single-pass process. The machined depths using the multi-pass method are dependent on scratching times and the applied normal loads. Moreover, the depth closed to the thickness of the film can be obtained by enlarging the number of the scratching cycles. However, with a longer scratching time, large tip wear can be found. For vibration assisted method, the machined depths are controlled by the vibration amplitude and the applied normal load. With the vibration in z direction increasing, the machined depth can be enlarged comparing with the single-pass, which makes the fabrication process be feasible. In addition, the vibration-assisted method contributes to less tip wear during the machining process. (C) 2015 Elsevier B.V. All rights reserved.

Md Analysis on Tip Geometry Effects in Afm-Based Lithography Process

Molecular Dynamics Simulation of Form Measurement Process of Soft Materials Using Atomic Force Microscope

Study on Effects of Tip Geometry on AFM Nanoscratching Tests

Effect of Cantilever Deformation and Tip-Sample Contact Area on AFM Nanoscratching

Modelling and experimental study of nanoscratching process on PMMA thin-film using AFM tip-based nanomachining approach

Characterization Study on Machining PMMA Thin-Film Using AFM Tip-Based Dynamic Plowing Lithography

Penetrating Process Analysis of AFM Diamond Tip

Effects of Atomic Force Microscope Silicon Tip Geometry on Large-Scale Nanomechanical Modification of the Polymer Surface

Molecular Dynamics Simulation of the Combination Effect of the Tip Inclination and Scratching Direction on Nanomachining of Single Crystal Silicon

Energy Dissipation Contributed on the Machined Depth Via Dynamic Plowing Lithography of Atomic Force Microscopy

Implementation of AFM Tip-Based Nanoscratching Process on Single Crystal Copper: Study of Material Removal State

Molecular Dynamics Simulation of Processing Using AFM Pin Tool

Molecular dynamics simulation of AFM scratching on silicon with varying load

Effects of AFM Tip-Based Direct and Vibration Assisted Scratching Methods on Nanogrooves Fabrication on a Polymer Resist

Mechanism of Material Removal and the Generation of Defects by Md Analysis in Three-Dimensional Simulation in Abrasive Processes

Removal Of Material On Nanometer Scale During Afm Cutting

Three Dimensional Molecular Dynamics Simulation of Nano-Lithography Process for Fabrication of Nanocomponents in Micro Electro Mechanical Systems (MEMS) Applications

Atomic Simulations of Tip-Based Nanomilling on Single-Crystal Copper

AFM tip-based mechanical nanomachining of 3D micro and nano-structures via the control of the scratching trajectory

Characterization of AFM Tip Parameters with Typical Si (100) Microstructures

Blunting and wear of AFM tips during dynamic lithography