Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Numerical Simulations of Residual Stresses and Warpage in Injection Molding

The Numerical Simulation of Residual Stresses and Warpage in Injection Molding

Simulations of Three-Dimensional Thermal Residual Stress and Warpage in Injection Molding

Numerical Simulation And Experimental Study Of Warpage Of Injection-Molded Parts

Numerical Simulation of Thermally Induced Stress and Warpage in Injection-Molded Thermoplastics

Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation

Warpage of Injection-Molded Thermoplastics Parts: Numerical Simulation and Experimental Validation

Simulation of Residual Stress in Viscoelastic Mold Filling Process

Warpage Analysis and Numerical Prediction of Molding Dimensions for Injection Mo Lded Parts

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Simulations of a Full Three‐dimensional Packing Process and Flow‐induced Stresses in Injection Molding

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Residual stress analysis of the post-filling stage in injection moulding

Residual Stress Simulation of Injection Molding

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Numerical Simulation of Mold Filling in Injection Molding of Viscoelastic Polymers

A Three-Dimensional Thermal Model for Viscoelastic Polymer Melt Packing Process in Injection Molding

Numerical simulation and experimental research on the injection mould deformation

Integrative Analysis of the Injection Molding Process and Mechanical Behavior of Plastic Part

Numerical Analysis of Volumetric Shrinkage and Warpage of Injection Molded Microcellular Parts

Pressure Analysis Of Dynamic Injection Molding And Process Parameter Optimization For Reducing Warpage Of Injection Molded Products