Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Prediction of welding distortion in multipass girth-butt welded pipes of different wall thickness

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Study on FEM Numerical Simulation Method for the Welding Distortion

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships

Characteristics of welding distortion and residual stresses in thin-walled pipes by solid-shell hybrid modelling and experimental verification

An algorithm for prediction of bending deformation induced by multi-seam welding of a steel-pipe structure

Numerical simulation of bending deformation induced by multi-seam welding of a steel-pipe structure

Theoretical Prediction of Welding Distortion Considering Positioning And the Gap Between Parts

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Analysis and mitigation of the bending deformation in girth-welded slender pipes with numerical modelling and experimental measurement

Mitigation of residual stress and deformation induced by TIG welding in thin-walled pipes through external constraint

Analysis of influence of initial gap of laser-arc hybrid butt welds on inherent strain and welding deformation of a pipe structure

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Study on the Prediction of Welding Distortion of Aluminium Alloy Based on Inherent Strain Method

Analysis of three-roller continuous and synchronous calibration process of straightness and ovality for large thin-walled pipes considering the weld

Fracture behavior analysis of X80 pipelines welded joints with unequal wall thickness

Inhomogeneous Strain Behaviors of the High Strength Pipeline Girth Weld under Longitudinal Loading

Welding Deformation Predictions of Thin-Wall Cylinders Using a Local-Global Method