Abstract:Summary A laboratory study of the alkaline-surfactant-polymer (ASP) process was conducted. It was found from phase-behavior studies that for a given synthetic surfactant and crude oil containing naph-thenic acids, optimal salinity depends only on the ratio of the moles of soap formed from the acids to the moles of synthetic surfactant present. Adsorption of anionic surfactants on carbonate surfaces is reduced substantially by sodium carbonate, but not by sodium hydroxide. The magnitude of the reduction with sodium carbonate decreases with increasing salinity. Particular attention was given to a surfactant blend of a pro-poxylated sulfate having a slightly branched C16–17 hydrocarbon chain and an internal olefin sulfonate. In contrast to alkyl/aryl sulfonates previously considered for EOR, alkaline solutions of this blend containing neither alcohol nor oil were single-phase micellar solutions at all salinities up to approximately optimal salinity with representative oils. Phase behavior with a west Texas crude oil at ambient temperature in the absence of alcohol was unusual in that colloidal material, perhaps another microemulsion having a higher soap content, was dispersed in the lower-phase microemulsion. Low interfacial tensions existed with the excess oil phase only when this material was present in sufficient amount in the spinning-drop device. Some birefringence was observed near and above optimal conditions. While this phase behavior is somewhat different from the conventional Winsor phase sequence, overall solubilization of oil and brine for this system was high, leading to low interfacial tensions over a wide salinity range and to excellent oil recovery in both dolomite and silica sandpacks. The sandpack experiments were performed with surfactant concentrations as low as 0.2 wt% and at a salinity well below optimal for the injected surfactant. It was necessary that sufficient polymer be present to provide adequate mobility control, and that salinity be below the value at which phase separation occurred in the polymer/surfactant solution. A 1D simulator was developed to model the process. By calculating transport of soap formed from the crude oil and injected surfactant separately, it showed that injection below optimal salinity was successful because a gradient in local soap-to-surfactant ratio developed during the process. This gradient increases robustness of the process in a manner similar to that of a salinity gradient in a conventional surfactant process. Predictions of the simulator were in excellent agreement with the sandpack results.

An experimental study on alkaline/surfactant/polymer flooding systems using nature mixed carboxylate

Simulation of nonlinear chromatographic process for surfactant-polymer flooding

Study on Sensitivities of Numerical Simulation Parameters in SP Flooding

A Novel Binary Compound Flooding System Based on DPG Particles for Enhancing Oil Recovery

Experimental Study of Enhancing Oil Recovery with Weak Base Alkaline/Surfactant/Polymer

Study on the Synergistic Effects between Petroleum Sulfonate and a Nonionic–Anionic Surfactant for Enhanced Oil Recovery

Study on Microscopic Oil Displacement Mechanism of Alkaline-Surfactant-Polymer Ternary Flooding

A novel binary flooding system of a biobased surfactant and hydrophobically associating polymer with ultralow interfacial tensions

Favorable Attributes of Alkali-Surfactant-Polymer Flooding

Improved Oil Recovery by Chemical Flood from High Salinity Reservoirs-Single-Well Surfactant Injection Test

Study on a Nonionic Surfactant/Nanoparticle Composite Flooding System for Enhanced Oil Recovery

Research on the ratio of multicomponent emulsion flooding system

Performance and Optimization of Biological and Chemical Composite Flooding System for Enhanced Oil Recovery

Development of the Surfactant-Based Chemical EOR Formula for Low Permeability Reservoirs

Laboratory evaluation and numerical simulation of the alkali–surfactant–polymer synergistic mechanism in chemical flooding

Experimental investigation on the effect of interfacial properties of chemical flooding for enhanced heavy oil recovery

Numerical Investigation on Alkaline-Surfactant-Polymer Alternating CO2 Flooding

Polyetheramine enhanced biosurfactant/biopolymer flooding for enhanced oil recovery

Study on the adaptability of binary flooding in a certain oil field

Experimental Investigation of Surfactant Partition in Heavy Oil/Water/Sand Systems

Pore scale experimental and numerical study of surfactant flooding for enhanced oil recovery