Abstract:Phase-change thermofluidic oscillator has drawn significant attention thanks to its low operating temperature, which is beneficial for recovering low-grade heat. The vapor-liquid coupling oscillation in the thermofluidic oscillator leads to complex non-linear mode transition phenomenon that affects the steady operation. In this work, the mode transition characteristics of a thermofluidic oscillator with external loads (i.e., a needle valve and a load reservoir) are experimentally investigated through bifurcation analysis. A low-order van der Pol model is employed to examine the effect of acoustic resistance on mode transition. Experimental results demonstrate that modifying the valve opening and load volume under a constant temperature difference can trigger bifurcation, resulting in high-frequency limit cycle, low-frequency limit cycle and quasi-periodic modes. The non-linear features of each mode are revealed through phase space and Poincare section, with Neimark-Sacker bifurcation, second bifurcation and inverse Neimark-Sacker bifurcation observed. Steady-state performance of oscillator is then characterized under different oscillation modes. The maximum pressure amplitudes measured are 11.54 kPa during the high-frequency oscillation and 1.35 kPa during the low-frequency oscillation, while the maximum displacement amplitudes obtained are 45.5 mm during the high-frequency oscillation and 91.4 mm during the low-frequency oscillation. The oscillation modes can be adjusted by external load to maximize output performance. This study offers comprehensive guidelines for constructing phase-change thermofluidic oscillators.

A Micromechanical Bridge-Shaped Voltage-Controlled Oscillator

A Novel Voltage-Controlled Oscillator Realized with A Microresonator

Experimental Investigation on the Mode Transition Characteristics of a Phase-Change Thermofluidic Oscillator with External Loads

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

A 60GHz voltage-controlled oscillator with a 3.6GHz tuning range in 180nm CMOS technology

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

Dielectric Resonators with High $Q$-Factor for Tunable Low Phase Noise Oscillators

A 92 Fsrms Jitter Frequency Synthesizer Based on a Multicore Class-C Voltage-Controlled Oscillator with Digital Automatic Amplitude Control

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

Thermally Excited Micromechanical Vacuum Resonator

A Ku-Band 20.4% Tuning Range VCO with a Tunable Harmonic-Resonant Transformer in 55 Nm CMOS

A Self-Temperature-compensated Micromechanical Bridge Resonator

Voltage-Controlled Mechanical Oscillator Based on Superconducting Membrane

A 20.7–31.8ghz Dual-Mode Voltage Waveform-Shaping Oscillator with 195.8dbc/hz FoMT in 28nm CMOS

A controllable superconducting electromechanical oscillator with a suspended membrane

A Resonator-Adaptable Oscillator Using Varactor-Loaded Tuned Amplifiers

Micromechanical resonators for oscillators and filters

A 1-Ghz LC Voltage-Controlled Oscillator with High Linearity and Wide Range

A 5.6∼8.2ghz QVCO with a New DCCA Circuit

A Harmonic-Tuned VCO With an Intrinsic-High- Q F 23 Inductor in 65-nm CMOS

Zinc oxide nanowire electromechanical oscillator