Abstract:Experimental evidences show that friction during rotor/stator rubbing may not always obey the Coulomb friction law, which is predominantly adopted in the studies of these kinds. This work is devoted to unveiling the effects of viscous damping in the friction model on forward and backward full annular rubbing responses in a piecewise smooth rotor/stator rubbing system. The effects induced by the viscous friction, which are exclusively different from those with pure Coulomb friction, may possibly be used as the signatures for identifying the presence/extent of viscous friction in rotor/stator rubbing tests. In this work, the boundaries of both forward and backward full annular rub motions are analytically derived based on the stability and bifurcation theory. Due to the introduction of viscous friction, the rotor/stator system changes from a piecewise smooth continuous system to a Fillipov one. The results show that the viscous friction has little influence on the region of backward full annular rubbing responses but has significant effects on the region of forward full annular rub motion. With the increase of the viscous friction, the parameter region of the forward full annular rub shrinks significantly, and the boundary of Hopf bifurcation changes increasingly from supercritical to subcritical. This leads to more complex behaviors in the global response characteristics in comparison with those of the rotor/stator rubbing system with Coulomb friction, for instance, two new quasiperiodic rubbing responses appear beside the quasiperiodic partial rub bifurcating from the synchronous full annular rub, including a new quasiperiodic full annular rub motion that is different from the traditional full annular rubs mentioned above.

CONTROL METHODS USING THE CROSS-COUPLING EFFECTS FOR ACTIVE SUPPRESSION OF ROTOR RUBBING

Reduction Methods Using Canceling Effect for Cogging Torque in Dual-Stator PM Synchronous Machines

The Influence Of The Cross-Coupling Effects On The Dynamics Of Rotor/Stator Rubbing

The Global Responses Characteristics of a Rotor/stator Rubbing System with Dry Friction Effects

Global Dynamical Characteristics of Rotor/Stator Systems Accounting for Stator Mass and Contact Surface Stiffness

Improvement of Rotor Performance under Rubbing Conditions Through Active Auxiliary Bearings

Unveiling the Effects of Viscous Friction on the Full Annular Rubs in a Piecewise Smooth Rotor/Stator Rubbing System

Dynamical Behaviors of Hybrid Squeeze Film Damper for Rotor System Vibration Control

A Variable Stiffness Damping Support For Passing Through The Critical Speeds Of Rotors

Dynamics Analysis Control on Dual Delay Bearing-Rotor System

Active Control of Bearing Force Transmissibility for Active Magnetic Bearings-rigid Rotor Systems

Modal decoupling control for active magnetic bearing-supported flywheel rotor system

Multi-objective Optimization of Active Dry Friction Damper-Rotor Systems Based on Predictive Control

ADVANCES IN THE RESEARCH ON NONLINEAR PHENOMONA IN ROTOR/STATOR RUBBING SYSTEMS

Rough surface damping contact model and its space mechanism application

The Partial and Full Rubbing of a Flywheel Rotor–bearing–stop System

Local Sensitivity Analysis of Steady-State Response of Rotors with Rub-Impact to Parameters of Rubbing Interfaces

Stability Analysis of Full Annular Rub in Rotor‐to‐Stator Systems

Rubbing Effect Analysis in a Continuous Rotor Model

Stability Analysis of Sliding Whirl in a Nonlinear Jeffcott Rotor with Cross-Coupling Stiffness Coefficients

Numerical And Experimental Investigation On The Controlling For Rotor-To-Stationary Part Rubbing In Rotating Machinery