Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

A Variable Stiffness Damping Support For Passing Through The Critical Speeds Of Rotors

Dynamical Behaviors of Hybrid Squeeze Film Damper for Rotor System Vibration Control

A Magneto-Rheological Fluid Squeeze Film Damper For Rotor Vibration Control

ANALYSIS OF THE MULTIPLE-SOLUTION RESPONSE OF A FLEXIBLE ROTOR SUPPORTED ON NON-LINEAR SQUEEZE FILM DAMPERS

An Experimental Study into Dynamic Behavior of a Magnetorheological Fluid Squeeze Film Damper – Overhung Flexible Rotor

Dynamics of A Rotor Supported on Magnet-Rheological Fluid Squeeze Film Damper

Active Vibration Control of a Flexible Rotor in Magnetically Suspended High-Speed Motor to Pass the First Bending Critical Speed with Optimal Phase Compensation Control

Active Vibration Control of Rotor System by A Magneto-Rheological Fluid Damper

Experimental Study on Rotor System Vibration Control of a Squeeze MR Fluid Damper

Rotor Passing Through Critical Speed with Assistance of Electromagnetic Damper

Vibration Control of a Radial Journal Eddy Current Damper on Flexible Rotor Systems

Dynamic analysis of the variable stiffness support rotor system with elastic rings

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

A Disk-Type Magneto-Rheological Fluid Damper for Rotor System Vibration Control

Dynamics Analysis Control on Dual Delay Bearing-Rotor System

Feedforward Decoupling Control for Rigid Rotor System of Active Magnetically Suspended High‐speed Motors

Rotor resonance avoidance by continuous adjustment of support stiffness

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Experimental Study on the Vibration Control Capability of a Hybrid Squeeze Film Damper

A Journal Eddy Current Damper for Rotor Systems

Nonlinear dynamics of asymmetrically supported supercritical rotor equipped with a dry friction damper