Abstract:Nanocrystalline pure perovskite phase bismuth sodium titanate (Bi0.5Na0.5)TiO3(BNT) powders have been prepared by a sol-gel method from the poly vinyl alcohol evaporation route. bismuth nitrate [Bi(NO3)(3)], tetra-butyl titanate [Ti(OC4H9)(4)] and sodium acetate(CH3COONa) were used as raw materials and poly vinyl alcohol(PVA) as the sol-gel forming solvent. Stoichiometric amounts of the individual raw materials were thoroughly mixed in accordance with the BNT composition to form the stock solution. The pH of the stock was adjusted to 1-3 by adding acetate. Aqueous solution of PVA[10%(w/v)] was then added to the cationic mixture with thorough stirring. The weight ratio of the cationic mixture to the PVA aqueous solution was maintained at 2:1. The resulting viscous liquid was then heated over a hot crucible up to form a fluffy dry gel. The fluffy dry gels were calcined at different temperatures and times and then cooled to room temperature naturally. The X-ray powder diffraction(XRD) patterns of the heat-treated powders were obtained using a Bruker D8 Advance X-ray diffractometer with Cu K alpha radiation and nickel filter. Scanning electron microscope (SEM) studies of the NBT powders were performed using a JSM-6700F electron microscope. Phase-pure BNT powders were obtained at 550 degrees C for 2-2.5h which is relatively lower calcination temperature than other reports. The BNT powders consists of phase-pure perovskite nanocrystals with an average size of 100-200nm.

Synthesis of Bi4-xNdxTi3O12 Thin Film by UV-Light Irradiation

STRUCTURE AND PROPERTIES OF Bi4-xNdxTi3O12 THIN FILMS PREPARED BY METAL-ORGANIC SOLUTION DEPOSITION

Structural and optical properties of Bi4−xNdxTi3O12 thin films prepared by metal-organic solution deposition

Preparation and Properties of Bi4 ? Xndxti3o12 Thin Films by Chemical Solution Deposition

Preparation and Properties of Bi 4 − x Nd x Ti 3 O 12 Thin Films by Chemical Solution Deposition

Optimization Hydrothermal Synthesis Conditions for Nano-Sized (na0.5 Bi0.495 Nd0.005 )tio3 Particles by an Orthogonal Experiment and Their Luminescence Performance.

Tuning the Structural and Optical Properties of Bismuth Titanate by Different Nd Substitution Content

Influence of the annealing temperature of the Bi4Ti3O12 seeding layer on the structural and electrical properties of Bi3.15Nd0.85Ti2.99Mn0.01O12 thin films

Preparation of (1− <i>x</i> %)(Na<sub>0.5</sub>Bi<sub>0.5</sub>)TiO<sub>3</sub>– <i>x</i> %SrTiO<sub>3</sub> thin films by a sol–gel method for dielectric tunable applications

Chemical Solution Processing and Properties of (bi,nd)(4)ti3o12 Ferroelectric Thin Films

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

Thermal and Piezoelectric Properties of Bi3.15Nd0.85Ti3O12 Thin Film Prepared by Metal Organic Decomposition

Improvement of Nucleation and Electrical Properties of Bi 3.15 Nd 0.85 Ti 2.99 Mn 0.01 O 12 Thin Films with an Upper Bi 4 Ti 3 O 12 Buffer Layer

Sol-Gel Synthesis and Characterization of Nanocrystalline (bi0.5na0.5)tio3 Powders from the Poly Vinyl Alcohol Evaporation Route

Tailoring Synthesis Conditions for [(ba0.85ca0.15)0.995nd0.005](ti0.9hf0.1)o3 Nanopowders by Hydrothermal Method and Their Luminescence Properties

Preparation of (1− x %)(Na 0.5 Bi 0.5 )TiO 3 – x %SrTiO 3 thin films by a sol–gel method for dielectric tunable applications

Processing and Properties of Rare Earth Ion-Doped Bismuth Titanate Thin Films by Chemical Solution Deposition Method

Preparation of Bi4Ti3O12 thin films by pulsed laser deposition at room temperature

Composition-Dependent Electrical Characteristics And Interface Microstructures Of Solution-Derived Nd-Substituted Bi4ti3o12 Thin Films On Pt Electrodes

Large piezoelectric properties of (1 − x)Na 0.5 Bi 0.5 TiO 3 –xBaTiO 3 thin films prepared by sol–gel method

Preparation and Characterization for B3.15Nd0.85Ti3O12 Thin Film by Sol-Gel Process