Comparison of Specification Method and Analysis Method for Fracture Prevention Analysis of Reactor Vessel

TIAN Yu,LEI Bai-mao,SHI Li,WAN Li

DOI: https://doi.org/10.3969/j.issn.0254-0053.2013.03.011

2013-01-01

Abstract:Aiming at the upper head part of the AP1000 reactor pressure vessel,the stress intensity factor of elliptical surface crack front in reactor startup and shutdown transient state were calculated by standard method.The calculation results show that in the reactor startup process,outer surface cracks of the upper head are more dangerous than the inner ones;while in shutdown process,inner surface cracks are more dangerous than the outer ones.For the area away from the discontinuous structure zones,it has little difference between circumferential and radial crack front stress intensity factor.But for the adjacent structure discontinuity,circumferential cracks are more dangerous than radial cracks in the reactor startup process;while in shutdown process,radial cracks are more dangerous than circumferential cracks.The evaluation shows that the defect conforms to ASME safety design requirements.At the same time,threedimensional finite element model with real crack was established and evaluation of fracture prevention was analyzed.Comparison of two methods shows that the traditional standard method is more conservative than finite element method./r/n