Abstract:Aimed at the vibration of whole aero-engine, a coupled dynamic model of rotor-ball bearing-stator of aero-engine is built. By means of the lumped mass method, taking into account the nonlinear rub-impact, bearing failure force and deformation of the casing, the dynamic equation of the system containing typical rub-impact is derived. The response of the system under different conditions is obtained by using the fourth order Runge-Kutta numerical integration algorithm. By adopting the finite element analysis software ANSYS, the finite element model of the rotor shaft is established and the first six-order natural frequencies of the rotor system are acquired. Taking advantage of the parameters of the signal in time domain and frequency domain, frequency characteristics are extracted as the fault features. The single-point rubbing experiment is carried out in the test rig, and the working speed is higher than the first critical speed, so the rotor shaft is flexible rotor. By the methods of spectrum and cepstrum analysis, the rub-impact characteristics of the casing vibration acceleration time series data are analyzed. The results show that the casing vibration acceleration has obvious impact characteristics; the impact frequency is equal to the product of rotating frequency and number of the blades; the impact frequency component and its multiple-frequencies are demonstrated in the frequency spectrum; the strength of impact is modulated by the rotating frequency, so that there are families of side bands on impact frequency and both sides of frequency doubling, and the interval of sideband equals the rotating frequency. The frequency components of the rotating frequency and its frequency doubling are clearly shown in the cepstrum. By comparing the simulation and experiment, the rubbing characteristics found out in this paper has enough accuracy.

Influence of Friction Coefficient on Vibration Characteristic of Rub- Impact Rotor with Axial Thrust

The Influence Of Damping Coefficient On Vibration Characteristic Of A Rub-Impact Rotor Under Axial Thrust

Nonlinear Dynamics of Rub-Impact on a Rotor-Rubber Bearing System with the Stribeck Friction Model

Axial Displacement and Rubbing Vibration of Rotor System Caused by Thermal Expansion

Rub-Impact Investigation of a Single-Rotor System Considering Coating Effect and Coating Hardness

Simulation of Rotor'S Axial Rub-Impact in Full Degrees of Freedom

Rub-impact Behavior Study of a Flywheel Rotor by Considering the Friction Coefficients Effect

Stiffening effect of the rotor during the rotor-to-stator rub in a rotating machine

Dynamic Characteristics of a Disk–drum–shaft Rotor System with Rub-Impact

Nonlinear Dynamics of a Rub-Impact Rotor Supported by Oil Film Bearings with an Elastic Stator

Study on Impacting-rub Fault Mechanism of Rotor-bearing System

Dynamics Analysis of an Impact-Rub Rotor by Finite Element Method

Dynamic Characteristics of Rub-Impact on Rotor System with Cylindrical Shell

Dynamic Characteristics and Experimental Research of Dual-Rotor System with Rub-Impact Fault

Dynamic Characteristics of Rotor System and Rub-Impact Fault Feature Research Based on Casing Acceleration

Investigation of Dynamic Characteristics of a Rotor System with Surface Coatings

Rubbing phenomena in rotor–stator contact

Rubbing Effect Analysis in a Continuous Rotor Model

Nonlinear dynamic of the rod-fastening combined rotor system with rub-impact based on the Stribeck friction model

Radial Vibration Characteristics of a Double-overhung Rub Rotor

Nonlinear Dynamic Analysis of Rub-Impact Rod-Fastening Combined Rotor Systems with Internal Damping