Abstract:The performance of direct methanol fuel cells (DMFCs) is constrained by the sluggish kinetics of methanol oxidation reaction. Increasing the temperature can effectively increase the methanol oxidation kinetics, offering new opportunities to achieve high performance. Here we studied the performance of DMFCs based on the newly developed silica impregnated phosphoric acid doped polybenzimidazole (PA/PBI/SiO2) composite membrane. The composite membrane shows a proton conductivity of 2.9-4.1 x 10(-2) S cm(-1) at temperatures between 200 and 250 degrees C and is stable at high temperatures. The cells using the composite membrane successfully delivered a peak power density of 136 mW cm(-2) and 237 mW cm(-2) at 260 degrees C using the Pt/C and PtRu/C as the anode catalysts, respectively. The cells with the PA/PBI/SiO2 composite membrane show a much higher power output than that with conventional PA/PSI membranes. Most importantly, the results demonstrate that there exists a distinct transition temperature around 205 degrees C for the performance of DMFCs. Above this transition temperature, the increase in power density with temperature is 208 mWcm(-2)/100 degrees C, which is more than 4 times higher than 50 mWcm(-2)/100 degrees C obtained at temperatures below 205 degrees C. The presence of such transition temperature for DMFCs is most likely due to the significantly enhanced kinetics of the methanol oxidation reaction at elevated temperatures. Operation at elevated temperatures, i.e., above 205 degrees C, is most effective to significantly enhance the power performance of DMFCs.

Optimized temperature control system integrated into a micro direct methanol fuel cell for extreme environments

A Micro Direct Methanol Fuel Cell Integrated with a Temperature Control System for Extreme Environments

Design of heater integrated into micro direct methanol fuel cell

Development of A Micro Direct Methanol Fuel Cell with Heat Control

Development of Anodic Flux and Temperature Controlling System for Micro Direct Methanol Fuel Cell

Heat transfer of micro direct methanol fuel cell

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

Development of Integrated Thermally Autonomous Reformed Methanol-Proton Exchange Membrane Fuel Cell System

Water and heat management of vapor-fed direct methanol fuel cells with a non-isothermal triple-phase mass transfer model

Development and performance analysis of a metallic micro-direct methanol fuel cell for high-performance applications

Effect of cathode gas flow patterns on performance of micro direct methanol fuel cell

A Micro Passive Direct Methanol Fuel Cell with High Performance Via Plasma Electrolytic Oxidation on Aluminum-Based Substrate

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

An Air-Breathing Micro Direct Methanol Fuel Cell with 3D KOH-Etched Cathode Structure

Heat and mass transfer characteristics in ducted air-breathing direct methanol fuel cells

Significantly Enhanced Performance of Direct Methanol Fuel Cells at Elevated Temperatures

Development of a Microwave Sensor for Real-Time Monitoring of a Micro Direct Methanol Fuel Cell

A Micro Direct Methanol Fuel Cell Using PDMS Assembly Technology

Design and Performance Analysis of an Air-Breathing Micro Direct Methanol Fuel Cell

Non-isothermal modeling of direct methanol fuel cell