Abstract:A novel underwater blast vibration test system is developed, consisting of a main acquisition storage terminal, software platform, and hole-blocking device was developed to experimentally collect and analyze the vibration data of submarine rocks exposed to drilling and blasting operations.Equations for predicting the vibration intensity during underwater drilling and blasting operations while accounting for the water depth were obtained via dimensional analysis, it is verified that water depth was an important factor affecting the vibration intensities felt by submarine rocks during underwater drilling and blasting by fitting the experimental vibration data.A reliable equation is proposed to predicting the vibration intensity induced by underwater blasting that incorporates the blasting distance, amount of charge, and the water depth of the blasting area and the measurement point as variables.All underwater drilling and blasting operations generate seismic waves. However, due to a lack of suitable vibration sensing instruments, most studies on the propagation of seismic waves have been limited to shorelines near construction areas or wharfs, whereas comparatively few studies have been conducted on the larger seafloor itself. To address this gap, a seafloor vibration sensor system was developed and applied in this study that consists of an autonomous acquisition storage terminal, software platform, and hole-plugging device that was designed to record the blasting vibration intensities received through submarine rocks at a given measurement point. Additionally, dimensional analyses were used to derive a predictive equation for the strength of blast vibrations that considered the influence of the water depth. By combining reliable vibration data obtained using the sensor system in submarine rock and the developed predictive equation, it was determined that the water depth was an important factor influencing the measured vibration strength. The results using the newly derived equation were compared to those determined using the Sadowski equation, which is commonly used on land, and it was found that predictions using the derived equation were closer to the experimental values with an average error of less than 10%, representing a significant improvement. Based on these results, the developed sensor system and preliminary theoretical basis was deemed suitable for studying the propagation behavior of submarine seismic waves generated by underwater drilling and blasting operations.

Field Test of the Drill-Bit Vibration Signal Detection Using Portable Seismometers

Signal detection of lateral resistivity LWD based on C4D technique with oil-based drilling fluid

Experimental Measurements of Seismoelectric Signals in Borehole Models

Seismic-while-drilling drill-bit source by ground force: Concept and application

An innovative measurement-while-drilling method applied in construction of underground stress relief hole with more vibration events

Experimental evaluation of rock disintegration detection in drilling by a new acoustic sensor method

Electrokinetic measurements of formation velocities with wireline seismoelectric logging and seismoelectric logging while drilling

Downhole Microseismic Monitoring Using Time-Division Multiplexed Fiber-Optic Accelerometer Array

Experimental studies on the mechanism of seismoelectric logging while drilling with multipole source

Unveiling the Signals from Extremely Noisy Microseismic Data for High-Resolution Hydraulic Fracturing Monitoring

Experimental Study on Reflection Superiority of Multisensors Measurement-While-Drilling of Roof Bolter

Experimental study of multipole seismoelectric logging while drilling

A smart look at monitoring while drilling (MWD) and optimizing using acoustic emission technique (AET)

EXPERIMENTS OF SHALLOW DRILLING FOR INSTALLATION OF STRAIN APPARATUS

Digital monitoring of rotary-percussive drilling with down-the-hole hammer for profiling weathered granitic ground

Influence of Drill Collar Wave on Multipolar Source Seismoelectric Logging While Drilling

Surface-wave geological exploration method based on Tunnel Boring Machine (TBM) drilling noise

Determining method for downhole drill string movement station by using drill string vibration frequency spectrum

Testing of a Permanent Orbital Surface Source and Distributed Acoustic Sensing for Monitoring of Unconventional Reservoirs: Preliminary Results from the Eagle Ford Shale

Monitoring and Prediction of the Vibration Intensity of Seismic Waves Induced in Underwater Rock by Underwater Drilling and Blasting

Detection of Precursory Wave Using a Novel Sensor and Its Application to Earthquake Prediction