Abstract:A novel underwater blast vibration test system is developed, consisting of a main acquisition storage terminal, software platform, and hole-blocking device was developed to experimentally collect and analyze the vibration data of submarine rocks exposed to drilling and blasting operations.Equations for predicting the vibration intensity during underwater drilling and blasting operations while accounting for the water depth were obtained via dimensional analysis, it is verified that water depth was an important factor affecting the vibration intensities felt by submarine rocks during underwater drilling and blasting by fitting the experimental vibration data.A reliable equation is proposed to predicting the vibration intensity induced by underwater blasting that incorporates the blasting distance, amount of charge, and the water depth of the blasting area and the measurement point as variables.All underwater drilling and blasting operations generate seismic waves. However, due to a lack of suitable vibration sensing instruments, most studies on the propagation of seismic waves have been limited to shorelines near construction areas or wharfs, whereas comparatively few studies have been conducted on the larger seafloor itself. To address this gap, a seafloor vibration sensor system was developed and applied in this study that consists of an autonomous acquisition storage terminal, software platform, and hole-plugging device that was designed to record the blasting vibration intensities received through submarine rocks at a given measurement point. Additionally, dimensional analyses were used to derive a predictive equation for the strength of blast vibrations that considered the influence of the water depth. By combining reliable vibration data obtained using the sensor system in submarine rock and the developed predictive equation, it was determined that the water depth was an important factor influencing the measured vibration strength. The results using the newly derived equation were compared to those determined using the Sadowski equation, which is commonly used on land, and it was found that predictions using the derived equation were closer to the experimental values with an average error of less than 10%, representing a significant improvement. Based on these results, the developed sensor system and preliminary theoretical basis was deemed suitable for studying the propagation behavior of submarine seismic waves generated by underwater drilling and blasting operations.

Monitoring and Prediction of the Vibration Intensity of Seismic Waves Induced in Underwater Rock by Underwater Drilling and Blasting

Integrated Amphibious Distributed Acoustic Sensing for Seismic Monitoring in the Xinfengjiang Reservoir

Numerical Simulation of Shock Wave Caused by Underwater Blasting

Vibration Safety Threshold and Control Technology for Blasting to Prevent Seawater Intrusion in Coastal Tunnel Sections Near Faults

Microseismic Monitoring of Rock Mass Fracture Response to Blasting Excavation of Large Underground Caverns Under High Geostress

A Method for Multihole Blasting Seismic Wave Prediction and Its Application in Pillar Recovery

Prediction of Vibration Waveform and Division of Influenced Partitions under the Action of Blasting

Experiments and simulation of block motion in underwater bench blasting

Prediction of Blasting Vibration Velocity of Layered Rock Mass under Multihole Cut Blasting

Propagation and Prediction of Blasting Vibration on Ground Surface Induced by Underground Mining with Comparison to Vibration Inside Rock

Monitoring and Analysis for Blasting Vibration of the Hydraulic Tunnel under Chamber Blasting

Vibration velocity and frequency characteristics of surrounding rock of adjacent tunnel under blasting excavation

Numerical Simulation of Rock Blasting in a Pipe-Jacking Project of China

Analysis of interaction between tunnel support system and surrounding rock for underwater mined tunnels considering the combined effect of blasting damage and seepage pressure

Analysis of vibration signals near ground surface during blasting excavation of a tunnel in fractured rock

Development of an Underwater Adaptive Penetration System for In Situ Monitoring of Marine Engineering Geology

Study on Blasting Vibration Simulating Darthquake

Multivariate Early Warning Method for Rockburst Monitoring Based on Microseismic Activity Characteristics

Propagation characteristics and prediction of blast-induced vibration on closely spaced rock tunnels

NUMERICAL SIMULATION STUDY ON SURFACE MASS POINT VERTICAL VIBRATION VELOCITY IN PIPE JACKING BLASTING

A Study on the Vibration Frequency of Blasting Excavation in Highly Stressed Rock Masses