Abstract:A novel underwater blast vibration test system is developed, consisting of a main acquisition storage terminal, software platform, and hole-blocking device was developed to experimentally collect and analyze the vibration data of submarine rocks exposed to drilling and blasting operations.Equations for predicting the vibration intensity during underwater drilling and blasting operations while accounting for the water depth were obtained via dimensional analysis, it is verified that water depth was an important factor affecting the vibration intensities felt by submarine rocks during underwater drilling and blasting by fitting the experimental vibration data.A reliable equation is proposed to predicting the vibration intensity induced by underwater blasting that incorporates the blasting distance, amount of charge, and the water depth of the blasting area and the measurement point as variables.All underwater drilling and blasting operations generate seismic waves. However, due to a lack of suitable vibration sensing instruments, most studies on the propagation of seismic waves have been limited to shorelines near construction areas or wharfs, whereas comparatively few studies have been conducted on the larger seafloor itself. To address this gap, a seafloor vibration sensor system was developed and applied in this study that consists of an autonomous acquisition storage terminal, software platform, and hole-plugging device that was designed to record the blasting vibration intensities received through submarine rocks at a given measurement point. Additionally, dimensional analyses were used to derive a predictive equation for the strength of blast vibrations that considered the influence of the water depth. By combining reliable vibration data obtained using the sensor system in submarine rock and the developed predictive equation, it was determined that the water depth was an important factor influencing the measured vibration strength. The results using the newly derived equation were compared to those determined using the Sadowski equation, which is commonly used on land, and it was found that predictions using the derived equation were closer to the experimental values with an average error of less than 10%, representing a significant improvement. Based on these results, the developed sensor system and preliminary theoretical basis was deemed suitable for studying the propagation behavior of submarine seismic waves generated by underwater drilling and blasting operations.

Prediction of Vibration Waveform and Division of Influenced Partitions under the Action of Blasting

Numerical Simulation of Dynamic Damage and Stability of a Bedding Rock Slope under Blasting Load

Prediction of Blasting Vibration Velocity of Layered Rock Mass under Multihole Cut Blasting

Research on vibration effect of tunnel blasting based on an improved Hilbert–Huang transform

Vibration velocity and frequency characteristics of surrounding rock of adjacent tunnel under blasting excavation

Reduction of Blasting Induced Ground Vibrations Using High-Precision Digital Electronic Detonators

Propagation characteristics and prediction of blast-induced vibration on closely spaced rock tunnels

STUDY OF SAFETY EVALUATION METHOD OF BLASTING VIBRATION BASED ON INPUT ENERGY

Optimization of Blasting Parameters Considering Both Vibration Reduction and Profile Control: A Case Study in a Mountain Hard Rock Tunnel

Experimental Investigation of the Propagation and Attenuation Rule of Blasting Vibration Wave Parameters Based on the Damage Accumulation Effect

Monitoring and Prediction of the Vibration Intensity of Seismic Waves Induced in Underwater Rock by Underwater Drilling and Blasting

Study on the Attenuation Parameters of Blasting Vibration Velocity in Jointed Rock Masses

A Method for Multihole Blasting Seismic Wave Prediction and Its Application in Pillar Recovery

Prediction formula of blasting vibration under complex terrain based on dimensional analysis

Vibration response and evaluation system of cross-tunnel blasting

Ground-Borne Vibration Model in the Near Field of Tunnel Blasting

Wavelet Packet Analysis on Blasting Vibration Signal under Different Cutting Method

Analysis of Energy Distribution for Digital Electronic Detonator Blasting

Empirical prediction of blast-induced vibration on adjacent tunnels

Dynamic response of rock mass subjected to blasting disturbance during tunnel shaft excavation: a field study

Positional Parameter Engineering Calculation of Divided Charges in Chamber Blasting