Abstract:<p>When drilling ultra-deep wells with polycrystalline diamond compact (PDC) bits, the drillstring suffered from severe vibrations that were responsible for the premature failure of drillstring components and the inefficient drilling process. In this paper, a field experiment was conducted in an ultra-deep well to measure the downhole tri-axial accelerations of the drillstring. The analyses of the acceleration data in the time and frequency domains show that the drillstring is subjected mainly to violent stick–slip and whirling vibrations. Comparisons between two adjacent sets of tri-axial acceleration data suggest that the occurrence of stick–slip oscillations intensifies the downhole drillstring whirling vibrations. To numerically study the measured stick–slip and whirling vibrations, a fully coupled finite element model for the axial, torsional and lateral vibrations of the drillstring is developed. The bit-rock interaction, which is responsible for the stick–slip oscillations, is modelled by a non-regularized dry friction law, the key parameters of which are fitted by the experimental results. Hertzian contact theory is used to model the nonlinear contacts between the drillstring and the wellbore wall. The downhole angular velocity fluctuations that are due to the stick–slip oscillations are also considered, and they lead to the coupling between the stick–slip and the whirling vibrations. The satisfactory agreement between the numerical and experimental results supports the fidelity of the proposed finite element model. The experimentally observed intensifying effects of the stick–slip oscillations on the whirling vibrations are verified via comparisons between simulation results with and without consideration of the coupling effects. On this basis, parametric studies are conducted to analyze the influence of the drilling parameters on the stick–slip oscillations and the whirling behaviors.</p>

Determining method for downhole drill string movement station by using drill string vibration frequency spectrum

Experimental Analysis of Acoustic Transmission Characteristics along the Periodic Simulated Drillstring

Virtual-instrument Based on Multithread Measurement Methods for Four-Component Forces in Drill Strings

Experimental Analysis of Acoustic Signal Detection Using Extensional Stress Wave Along the Periodic Simulated Drillstring

Measurement and simulation of nonlinear drillstring stick–slip and whirling vibrations

Measurement Method and Experimental Research on Dynamic Force Behavior of Bottom Drill String

Acoustic Transmission and Measurement Method for Near-bit Dynamic Force Signal of Bottom Drill String

Modeling and analysis of acoustic transmission characteristics in drillstring

Bearing Fault Detection Via Wavelet Packet Transform and Rough Set Theory

Improved Methods for Acoustic Transmission along the Drill String and Other Periodic Media

Characteristics Analysis of Joint Acoustic Echo and Noise Suppression in Periodic Drillstring Waveguide

A Method of Reducing Friction and Improving the Penetration Rate by Safely Vibrating the Drill-String at Surface

Study on Vibration Energy Conversion Efficiency of the Drill String Absorption & Hydraulic Supercharging Device

An innovative measurement-while-drilling method applied in construction of underground stress relief hole with more vibration events

Automatic identification of fundamental frequency for tied arch bridge suspender tension monitoring

Signal wireless transmission behaviors along the drillstring using extensional stress waves

Accurate Location Method of Drilling Hole Activities on Oil Pipelines Based on Wavelet Packet

Analysis on the dynamic characteristics of stick-slip vibration in deep well drill string system

Research on the Cooperative Detection of Stochastic Resonance and Chaos for Weak SNR Signals in Measurement While Drilling

Fault Diagnosis of Rolling Bearing Based on Wavelet Packet and Fourier Analysis

Study on Virtual Measurement Technology for Near-Bit Dynamic Forces of Bottom-Hole Assembly