Abstract:Downhole acoustic telemetry (DAT), using a long drill string with periodical structures as the channel, is a prospective technology for improving the transmission rate of logging while drilling (LWD) data. Previous studies only focused on the acoustic property of a free drill string and neglected the coupling between pipes and fluid-filled boreholes. In addition to the drill-string waves, a series of fluid waves are recorded in the DAT channel, which has not been investigated yet. Unpredictable channel characteristics result in lower transmission rates and stability than expected. Therefore, a more realistic channel model is needed considering the fluid-filled borehole. In this paper, we propose a hybrid modeling method to investigate the response characteristics of the DAT channel. By combining the axial wavenumbers and excitation functions of mode waves in radially layered LWD structures, the channel model is approximated to the 1-D propagation, which considers transmission, reflection, and interconversion of the drill-string and fluid waves. The proposed 1-D approximation has been well validated by comparing the 2-D finite-difference modeling. It is revealed that the transmitted and converted fluid waves interfere with the drill-string wave, which characterizes the DAT channel as a particular coherent multi-path channel. When a fluid-filled borehole surrounds the drill string, the channel responses exhibit considerable delay as well as strong frequency selectivity in amplitude and phase. These new findings suggest that the complexity of the channel response has been underestimated in the past, and therefore channel measurements on the ground are unreliable. To address these channel characteristics, we apply a non-coherent demodulation strategy. The transmission rate for synthetic data reaches 15 bps in a 94.5 m long channel, indicating that the acoustic telemetry is promising to break the low-speed limitation of mud-pulse telemetry.

Experimental Analysis of Acoustic Signal Detection Using Extensional Stress Wave Along the Periodic Simulated Drillstring

Experimental Analysis of Acoustic Transmission Characteristics along the Periodic Simulated Drillstring

Signal wireless transmission behaviors along the drillstring using extensional stress waves

Analysis of OFDM modulation method and experiment for acoustic transmission system along drill strings

Improved Methods for Acoustic Transmission along the Drill String and Other Periodic Media

Coherent OTDR Based Ultra-High Sensitive Acoustic Sensor Assisted with Distributed Microstructured Optical Fiber(DMOF) and Hollow Cylinder Transducer

Analysis of Acoustic Transmission Method in the Periodic Cascade Channel with Its Application to Drill Pipes

Characteristics Analysis of Joint Acoustic Echo and Noise Suppression in Periodic Drillstring Waveguide

Acoustic Transmission and Measurement Method for Near-bit Dynamic Force Signal of Bottom Drill String

Multi-carrier modulation excitation analysis for acoustic transmission signal in a drillstring

An experimental rig for near-bit force measurement and drillstring acoustic transmission of BHA

Modeling and analysis of acoustic transmission characteristics in drillstring

Simulation of stress waves in attenuating drill strings, including piezoelectric sources and sensors

Response analyses on the drill-string channel for logging while drilling telemetry

Experimental Study on Downhole Acoustic Wave Propagation Characteristics in Curved Drill String

Design of Acoustic Wireless Remote Transmission System for Logging-While-drilling Data

Analysis of echo cancellation method using two acoustic receivers in a drill string channel

Effect of Damping Boundary Conditions on Acoustic Transmission of Drill Strings

INFLUENCE OF DISCONTINUOUS BOUNDARIES ON ACOUSTIC TRANSMISSION IN PERIODIC CASCADE WITH APPLICATION TO DRILL PIPES

Wireless MWD Continuous Wave Signal Transfer Model and Simulation

Research on the Logging While Drilling Data Transmission Method of V-OFDM Based on Drillstring Acoustic Channel