Abstract:Downhole vibration, such as backward or chaotic whirling, is one of the primary causes for drill string failure during drilling operation. Understanding drilling dynamics is crucial for determining the mechanism of vibration and fatigue accumulation so as to mitigate risk of drill string failure. Drilling dynamics or vibration data can either be obtained from real-time measurement or simulation based on dynamics model, which plays a crucial role for drilling optimization in pre-drill planning phase. An advanced 4D drilling dynamics model, which considers the interaction between drill bit and formation, impact and friction between drill string and wellbore, constraints exerted on drill string and drill bit, is proposed to simulate the distribution and variation of 3D displacement, velocity, acceleration as well as the stress state of entire drill string within specified time period. This time domain model allows exploration of the full range of dynamics response under different drilling scenarios, which helps to optimize the performance and reliability of BHA as well as WOB/RPM selection. Moreover, drill string fatigue life prediction can also be achieved by combing simulated stress state and fatigue accumulation theory. Simulation shows that BHA with smaller- sized drill collar or fewer stabilizers are more susceptible to backward and even chaotic whirling while drilling. Also, inappropriate WOB/RPM combinations such as low WOB with high RPM could also cause the onset of severe lateral vibration. High frequency bending stress, mainly concentrated on BHA and caused by lateral vibration, is the main reason for rapid fatigue accumulation and continuous severe vibration could even result in drill string fatigue failure within hours. These findings helped to justify the 5 consecutive BHA failure and 1 washout while drilling the 171/2" wellbore with 7621 ft length of an ultra-deep well. Simulation also showed that downhole lateral vibration severity was significantly reduced after optimizing drill bit design, adopting BHA with larger stiffness and optimizing drilling parameters, which guaranteed the successful drilling of a new 171/2" wellbore with 4659 ft length of another offset well without downhole accident. This 4D drilling dynamics model could be used to conduct comparative analysis of dynamics responses based on specific criteria to identify the optimum BHA design and drilling parameters, which shows great potential in drill string fatigue failure prevention and drilling optimization.

An experimental rig for near-bit force measurement and drillstring acoustic transmission of BHA

Measurement Method and Experimental Research on Dynamic Force Behavior of Bottom Drill String

Study on Virtual Measurement Technology for Near-Bit Dynamic Forces of Bottom-Hole Assembly

Acoustic Transmission and Measurement Method for Near-bit Dynamic Force Signal of Bottom Drill String

Experimental Analysis of Acoustic Transmission Characteristics along the Periodic Simulated Drillstring

Signal wireless transmission behaviors along the drillstring using extensional stress waves

Experimental Analysis of Acoustic Signal Detection Using Extensional Stress Wave Along the Periodic Simulated Drillstring

Improved Methods for Acoustic Transmission along the Drill String and Other Periodic Media

Finite Element Dynamics Emulation of BHA

Characteristics Analysis of Joint Acoustic Echo and Noise Suppression in Periodic Drillstring Waveguide

Virtual-instrument Based on Multithread Measurement Methods for Four-Component Forces in Drill Strings

Modeling and Experimental Study on Motion States of Laboratory-Scale Bottom Hole Assembly in Horizontal Wells

Modeling and experimental investigation of drilling force for low-frequency axial vibration-assisted BTA deep hole drilling

Study on lateral vibration characteristics of BHA with double-span drill collar

Analysis of Acoustic Transmission Method in the Periodic Cascade Channel with Its Application to Drill Pipes

Simulation of the Borehole Quasistatic Electric Field Excited by the Acoustic Wave During Logging While Drilling Due to Electrokinetic Effect

Advanced 4D Drilling Dynamics Model Simulates Downhole Vibration and Helps to Optimize in Preventing Drill String Failure

Response analyses on the drill-string channel for logging while drilling telemetry

Simulation of stress waves in attenuating drill strings, including piezoelectric sources and sensors

Experimental Study on Downhole Acoustic Wave Propagation Characteristics in Curved Drill String

Measurement and simulation of nonlinear drillstring stick–slip and whirling vibrations