Abstract:This paper presents steady-state thermal-hydraulic analyses of various lattices of externally and internally cooled annular pressurized water reactor (PWR) fuel to identify the geometry that allows the largest possible power density while maintaining or increasing the minimum departure from nucleate boiling ratio (MDNBR) margin in current PWRs. Differences from the typical solid rod fuel are identified, and tools for the analysis are established. These involve an in-house code developed for this purpose and an adaptation of the VIPRE-01 whole-core model using a built-in heated tube option. A 13 × 13 square array that maintains the same assembly dimensions as the current 17 × 17 fuel assembly and keeps the same fuel-to-moderator ratio was identified to achieve the best performance and the largest MDNBR margin. It is demonstrated that with a proportional increase of the core flow rate, the annular fuel allows for an up to 50% power uprate at the same MDNBR margin as in current solid PWR fuel, or for a smaller uprate with larger MDNBR margins. The same uprate was found to be possible if annular fuel is used with a hexagonal lattice, such as in VVER plants. Even at this large power rating, the peak fuel temperature is smaller by hundreds of degrees centigrade than for the solid fuel. Analyses have also shown that the annular fuel is stable against both a power excursion and density wave oscillations and has only small sensitivity to oxide layer growth and manufacturing tolerances. Gap conductance asymmetry (between the inner and outer gaps) was identified as the key issue that will limit the design because gap heat transfer resistance affects the MNDBR, unlike for the solid fuel. The annular fuel MNDBR was also found to be more sensitive to variations in core operating parameters than solid fuel, but this is more than compensated for by a significantly larger MDNBR margin during normal operation.

Thermal hydraulic analysis of the thorium-based advanced CANDU Reactor fuel channel

Subchannel Analysis for Thorium-Based Advanced CANDU Reactor

Subchannel Analysis in Fuel Channels of TACR

Research on Power Effect of Th-U Fuel on TACR (thorium Based Advanced CANDU Reactor)

Development of sub-channel analysis code for CANDU-SCWR

Thermal Hydraulic Review of Light Water Reactor Based on Subchannel Code CTF

Sub-channel Analysis of CANDU–SCWR and Review of Heat-Transfer Correlations

Thermal Analysis on NAC-STC Spent Fuel Transport Cask under Different Transport Conditions

Research on Fuel Cycle of Thorium Advanced CANDU Reactor

CorTAF: A nuclear reactor core three-dimensional thermal-hydraulic characteristics analysis code based on OpenFOAM

Researches on Special Thermal Hydraulic Phenomena of Annular Fuel Assembly by Sub-Channel Analysis Code-NACAF

Analysis of heat transfer and solidification within CANDU corium

A Review of CFD Advancements Toward Thermal-Hydraulic Analysis of Prototypical Flow Conditions in PWR Subchannels

Unstructured Grid and Unstructured Grid Porous Methods for Numerical Analysis of TACR Moderator Calandria

CFD study of two-phase cross flow and heat transfer in sub-channels of pressurized water reactor fuel assemblies

Thermal-Hydraulic Design of High-Power-Density Annular Fuel in PWRs

Analysis of hypothetical channel flow blockage of a tubular fuel assembly in a 10 MWth nuclear research reactor

Single heated channel analysis of the AP-Th 1000 concept

Toxicity of irradiated advanced heavy water reactor fuels

Development of a thermal-hydraulic analysis code TAC-DS for spent fuel dry-storage system for high-temperature pebble bed reactor

Design of Passive Heat-Switch Between Pressure Tube and Calandria Tube Based on the Principle of Metal Expand on Heating and Contract on Cooling of TACR