Abstract:This study aims to advance understanding and visualization of the passive flow inside the core channels of a dual-channel plenum-to-plenum test facility designed as representative geometry of nuclear prismatic modular reactors core. Simultaneous experimental measurements of local surface and coolant fluid temperatures and flow fields in addition to local heat transfer coefficients were provided by integrating sophisticated flow dynamics and heat transfer techniques at different axial locations (Z/L=0.04,0.28,0.41,0.59,0.77,0.96) along the facility heated channel. Results emphasize the significant dependency of thermal and flow fields, of naturally driven gas, on heating intensity and configuration. Interestingly, although the entire length of the channel is subjected to heating, an inflection in surface and gas temperature in addition to changes in velocity distribution were observed through the top section of the heated channel. This highlights the significance of the complexity of the facility which causes severe interactions, and potential recirculation and back mixing, between rising hot gas with the cold gas in the upper plenum. This is validated by the negative heat flux measurements collected at the top section of the channel indicating heat reversal where heat is transferred from air to the channel. Moreover, densitometric Froude number for different heating profiles were estimated and found to range from 0.66 to 0.75 indicating the existence of a jet flow at the hot channel outlet. The obtained results provide valuable benchmark data for validating further investigations by computational fluid dynamics (CFD) and to perform further investigations of thermal hydraulics in prismatic block reactors.

Single heated channel analysis of the AP-Th 1000 concept

Numerical Simulation of Temperature Heterogeneity Inside the AP1000 Upper Plenum and Hot Leg

Analysis of Heat Transfer and Flow Characteristics of AP1000 Passive Residual Heat Removal Heat Exchanger

CFD study of two-phase cross flow and heat transfer in sub-channels of pressurized water reactor fuel assemblies

Sub-channel thermal-hydraulic analysis for VVER- 1000 generation III PWR

Core and Sub-Channel Evaluation of A Thermal Scwr

Research on Single Channel and Subchannel in Thermal-hydraulic Analysis of TP-1 Sodium Cooled TWR

Thermal Safety Analysis of New Type Heat Pipe Reactor Core

Cfd Analysis of Heat Transfer in Subchannels of A Super Fast Reactor

Analysis of hypothetical channel flow blockage of a tubular fuel assembly in a 10 MWth nuclear research reactor

Thermal hydraulic analysis of the thorium-based advanced CANDU Reactor fuel channel

Assessment of 1-D Channel Flow Models for Tritium Breeding Blanket Cooling

Coupled Monte Carlo and Thermal-Hydraulics Modeling for the Three-Dimensional Steady-State Analysis of the Xi'an Pulsed Reactor

CFD Investigation on Thermal Hydraulics of the Passive Residual Heat Removal Heat Exchanger (PRHR HX)

CFD Analysis on Subcooled Boiling Phenomena in PWR Coolant Channel

Characterizing passive flow in nuclear prismatic modular reactor core channels: Temperature, velocity, and heat transfer analysis

Numerical simulation on coolant flow and heat transfer in core

Numerical Simulation of Flow Distribution in the Lower Plenum of NHR200-II

Mechanistic Model of Critical Heat Flux in Rod Bundles Based on a High-Precision Subchannel Code

Steady-state Thermal Fluids Analysis for the HTR-PM Equilibrium Core

Prediction of Flow and Temperature Distributions in a High Flux Research Reactor Using the Porous Media Approach