Abstract:There are heat transfer correlations for heat transfer analysis in single tube geometries after several experimental and theoretical heat transfer studies in these single tube geometries. This is not the case for heat transfer analysis in rod bundle geometry with regard to proposed square fuel assembly of the Supercritical-Water-Cooled Reactor (SCWR) European Atomic Energy (EURATOM) design. Thus limited heat transfer studies exist on rod bundle geometry at supercritical pressures. Heat transfer correlations with accurate prediction capabilities of coolant and wall temperatures will be helpful in carrying out heat transfer studies at supercritical pressures. This paper presents the performance of twelve selected heat transfer correlations assessed on the 1/8th bare square fuel assembly of the SCWR EURATOM design using Simulation of Turbulent flow in Arbitrary Regions Computational Continuum Mechanics C ++ based code (STAR-CCM + CFD code). The obtained numerical results were compared with the results obtained by Waata numerical experimentation. Overall, the Cheng et al. correlation provided the most satisfying prediction for the wall temperatures in all the sub-channels and captured closely Wataa's Numerical data. The maximum wall temperature was obtained in sub-channel 9, the hottest sub-channel and exceeded the design limit 620 °C by 60 °C for the Cheng correlation. The difference in temperature between the hottest and coldest sub-channels 9 and 1 respectively was approximately 80 °C. It was found that Cheng correlation is best suited for heat transfer prediction in rod bundle geometry at supercritical pressures with regard to the proposed square fuel assembly of the SCWR EURATOM design. It was also found that the different numerical tools adopted for this study and Waata study were able to capture the trends of normal, enhanced and deteriorated heat transfer regimes normally observed at supercritical pressures. Nevertheless, experimental investigations involving rod bundles adopted in this study should be conducted to validate the results obtained numerically and address the inconsistency of the conclusions drawn when compared with Waata data and other similar studies.

Sub-channel Analysis of CANDU–SCWR and Review of Heat-Transfer Correlations

Development of sub-channel analysis code for CANDU-SCWR

Subchannel analysis of CANDU-SCWR fuel

Coupled neutronics/thermal–hydraulics analysis of CANDU–SCWR fuel channel

Sub-Channel Analysis Of Scwr Assembly With Double-Row Rods

Core and Sub-Channel Evaluation of A Thermal Scwr

SCWR subchannel code ATHAS development and CANDU-SCWR analysis

Effects of Circumferential Heat Conduction in Fuel Rods on Sub-channel Analysis for SCWR Core

Core Design Study on CANDU-SCWR with 3D Neutronics/thermal-Hydraulics Coupling

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

A Correlation Of Heat Transfer Non-Uniformity In Rod Bundle And Its Application To Sub-Channel Code

Analysis For Inverse Flow In Moderator Channels Of Supercritical Water Cooled Reactor

Cfd Analysis of Heat Transfer in Subchannels of A Super Fast Reactor

Conceptual Design of Candu-Scwr with Thermal-Hydraulics Coupling

Subchannel Thermal-Hydraulic Analysis of the Fuel Assembly for Liquid Sodium Cooled Fast Reactor

Analysis of the Sub-Channel of SCWR Two-Row Fuel Assembly

Experimental Investigation on Heat Transfer of Supercritical Pressure Water Flowing in Sub-Channel with Triangle Distribution in Reactors

CFD Analysis on Subcooled Boiling Phenomena in PWR Coolant Channel

Numerical Investigation for the Heat Transfer Mechanisms Between Subchannels of Bar Rod Bundles Cooled by Liquid Sodium

Thermal-hydraulic analysis of flow blockage in a supercritical water-cooled fuel bundle with sub-channel code

Experimental Investigation on Heat Transfer Characteristics of Subcritical Pressure Water Flowing in Subchannel with Square Distribution in SCWR