Low-Frequency Discontinuous Noise Diagnosis and Reduction of Air Conditioner Outdoor Unit
Luyao Mao,Hailin Ma,Danfeng Long,Liang Zhang,Qiyu Chen
DOI: https://doi.org/10.1088/1742-6596/2660/1/012044
2023-12-01
Journal of Physics: Conference Series
Abstract:Abstract Abnormal discontinuous low-frequency noise occurs in the outdoor unit when the air conditioner is operating at 86~96 Hz. This noise has the characteristics of low frequency, strong penetration, long transmission distance, and poor sound quality, which can cause serious noise pollution. In order to reduce the low-frequency noise of the outdoor unit of the air conditioner, the discontinuous noise frequency is first located by testing the time-domain and frequency-domain maps of the noise. It is then compared with the frequency of fan rotation noise and structural radiation noise. It is found that the discontinuous noise is caused by the coupling of fan rotation noise and structural radiation noise. It is found that low-frequency noise improvement is significant when the frequency difference between two noise peaks is greater than 8 Hz or when a single noise peak is less than 25 dB(A) by studying the methods of frequency modulation and amplitude modulation of noise peaks. By adjusting the fan speed from 930 rpm to 940 rpm, the problem of 94 Hz noise is solved. Then, through testing the natural frequencies of the pipe and shell, it is found that the natural frequencies of the pipe are close to the excitation frequencies. The structural radiation noise is mainly caused by the pipe. Modal analysis is conducted on the pipe. When the normal boundary with the condenser and the normal boundary with the valve of the pipe is constrained by springs, the simulated values are closer to the measured values. Finally, structural optimization design is carried out on the pipe. When the U-tube of the exhaust pipe is shortened by 30 mm, a 30 g mass block is added to the cold inlet pipe, and a 97 g mass block is added to the lower part of the valve pipe of the suction pipe. The discontinuous noise of the optimized prototype is significantly improved.