Abstract:In the outdoor unit of a room air conditioner, the main factors that made it possible to vary the ability of cooling and heating are the development of BLDC motors, advances in inverter technology, and the development of refrigerant volume control technology. The main reason for this change in cooling and heating capacity is that it is possible to change the RPS of compressors. As the range of the compressor's RPS expands, so does the range of response to load variations. This is mainly based on the capacity of the high-pressure refrigerant produced by the compressor. When the compressor rotates at high speed or low speed, the difference in noise occurs depending on the difference in rotational speed. Of course, fans and motors also contribute to noise fluctuations, but the overall governing factor is the greater contribution of refrigerant from compressors and compressors. The refrigerant flows into the cycle configured in the outdoor unit and varies in speed and flow rate depending on the amount of refrigerant. This results in vibration and noise appearing in the form of radiations, resonances, solid sounds, resonances, and so on. There are several factors that can cause vibration or noise changes depending on the flow velocity and flow rate. In this paper, we selected reactance of compressor motors, mufflers directly connected to compressor discharge ports and accumulator at compressor inlet where fluid vibrations occur the most. First of all, reactance of motor responds quickly to load fluctuations and has a large instantaneous torque to instantaneous load fluctuations. The muffler, which is directly connected to the compressor discharge port, is the first Cavity where high-pressure gas meets, and can evaluate the concentration of kinetic energy that generates noise and improve the collection center to reduce fluctuating noise. The Accumulator is the part with the lowest temperature of refrigerant gas entering the compressor, and the rapid change in the flow path causes the most fluid to generate vibration and radiation of the structure. For this reason, we select three elements first. In this paper, we specifically describe the background of selecting three elements of an air conditioning outdoor unit for the variability of noise over RPS changes. We demonstrate that these factors can review the feasibility of the experiment, explain the results of the analysis, and possibility of reduce the variation noise.

Investigation of Acoustic and Aerodynamic Noise in Air Conditioner Outdoor Unit

Investigation of Noise Characteristics of Electric Vibrator Utilizing Acoustic Camera and Transfer Path Analysis

Experimental and numerical study on aerodynamic noise of outdoor unit of room air conditioner with different grilles

Quantitative Evaluation of Flow-Induced Fan Casing Structural Vibration and Noise Radiation of Air-Conditioner Outdoor Unit

Low-Frequency Discontinuous Noise Diagnosis and Reduction of Air Conditioner Outdoor Unit

The Inner Acoustic Field Variety Due to the Effect of Refrigerator Compressor Oil Based on Finite Element Analysis

Numerical Analysis of Noise Radiation from Refrigerator Compressor Shell

Numerical Simulation and Structure Optimization of Compressor Muffler

System analysis and determination of the noise source of outdoor unit of airconditioner

An Investigation of the Acoustic Enclosure of an Air Conditioning Compressor Using Response Surface Analysis and Topological Rigidity Optimization

Flow Field Analysis and Optimization Design of Fan Cover for the Duct System of the Split Air Conditioner’s Outdoor Unit

Development of flow-vibroacoustic coupled numerical methods for prediction of noise radiation due to flow-born vibration of compressor discharge piping system

Source Identification and Reduction of Noise for the Outdoor Unit of Room Air Conditioner

The Vibration Noise Control Theoretical Analysis & Experimental Research of Split-floor Type Air-conditioner's Indoor Unit

Study on the Impact of Shock Absorber on Vibration and Noise of Air-conditioner's Outdoor Unit

Parameter study of Variation noise in outdoor of air conditioner

Prediction of Flowfield and Acoustic Signature of a Split-type Air Conditioner

EMI Model of Air-conditioning Outdoor Machines

PERFORMANCE ASSESSMENT OF THE RANS TURBULENCE MODELS IN PREDICTION OF AERODYNAMIC NOISE FOR AIR-CONDITIONER INDOOR UNIT

Investigation study on the flow-induced noise by winglet and shroud shape of an axial flow fan at an outdoor unit of air conditioner

Prediction of Noise Reduction Effect with Acoustic Modeling