Abstract:The steam-water condensing ejector is widely used in many industrial fields and production processes. In the practical operation of ejectors in many systems such as nuclear reactors and underwater gas-ejection devices, the steam pressure is much higher than those in common direct heating systems or refrigeration systems. In addition, some non-condensable gas is inevitably mixed into steam jet. With the presence of non-condensable gas, the flow field and performance of ejector are significantly influenced by the changes in heat transfer characteristics. This paper presents a three-dimensional numerical simulation of the high-pressure steam-water condensing ejector with non-condensable gas based on inhomogeneous multiphase model. The steam inlet pressure, mass flow rate and non-condensable gas fraction are in the range of 0.70-2.40 MPa, 1019-3310 kg/(m2s) MPa and 0-0.05, respectively. The changes in steam plume shapes, distributions of thermal hydraulic parameters and pressure ratio are investigated under different boundary conditions. Numerical results show that the steam plume inside ejector transforms from ellipsoidal shape to divergent shape with the increase of steam inlet mass flow rate and the decrease of back pressure. The choking phenomenon in throat is found at divergent steam plume and the changes of flow field in diffuser do not spread upstream to the mixing chamber, so the thermal hydraulic pa-rameters in mixing chamber and pressure ratio of ejector keep unchanged. In addition, the pressure ratio first increases from 1.08 to 2.34, then decreases to 1.99 with the increase of steam mass flux. As back pressure rises, the pressure ratio drops from 2.00 to 1.30 at low steam inlet mass flux; while first increasing linearly from 1.98 to 2.41 and then decreasing to 1.78 at high steam inlet mass flux. With the increase of non-condensable gas mass fraction, the pressure ratio slowly decreases from 1.48 to 1.39 at low steam mass flux while rapidly decreasing from 4.00 to 1.65 at high steam mass flux.

Performance computation and analysis of steam ejector

Performance Simulation and Analysis of Steam Ejector under Different Operating Condition

Performance simulation and analysis of steam ejector

Performance Analysis of A Steam Ejector for A Steam Eject Refrigeration System

Theoretical Study on Predicting the Performance of Steam Ejector by Analogy Method

An Investigation on the Component Efficiencies of a Small Two-Phase Ejector

Ejector Used in Transcritical CO_2 Heat Pump System

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

Analysis on the Optimal Mixing Pressure and Efficiency Limit of an Ideal Ejector

Numerical investigation on performance optimization of steam ejector considering full geometric parameters and working conditions

Performance Improvement of Two-Phase Steam Ejector based on CFD Techniques, Response Surface Methodology and Genetic Algorithm

Optimal Design of Steam Ejector by Computational Fluid Dynamics Simulation

Numerical investigation of the effect of primary nozzle geometries on flow structure and ejector performance for optimal design

An experimental and theoretical study of a CO2 ejector

Impact of inlet steam state on ejector internal flow and performance considering non-equilibrium condensation

Changing Condition Performance and Energy Analysis of Steam-Jetting Pumps

Numerical Simulation on the Direct Contact Condensation in a Steam-Water Two-Phase Ejector with Non-Condensable Gas

Improvement of the wet steam ejector performance in a refrigeration cycle via changing the ejector geometry by a novel EEC (Entropy generation, Entrainment ratio, and Coefficient of performance) method

Performance of Transcritical Carbon Dioxide System with Ejector

An Improved 1-D Thermodynamic Modeling of Small Two-Phase Ejector for Performance Prediction and Design

Numerical investigation of spindle position effects on steam ejector performance with a nonequilibrium condensation model