Abstract:Activated alumina has a porous structure and large specific surface area. It is often used as a catalyst carrier for various reactions. Currently, solution-phase methods (sol–gel reactions) that cause environmental pollution and resource waste are often used to synthesise activated alumina. To overcome this disadvantage, in this study, an eco-friendly low-heat solid-phase precursor method was developed to prepare activated alumina with improved properties (phase stability and specific surface area). The difference between the activated alumina synthesised by this method and a sol–gel method was studied in terms of the specific surface area and high thermal stability. The results indicated that after 4 h of treatment at 1100 °C, pure activated alumina obtained by the low-heat solid-phase precursor method maintained the γ-phase and had a specific surface area of 92 m2/g and pore volume of 0.68 cm3/g. On the other hand, pure activated alumina produced by the sol–gel method mainly consisted of the α-phase and had a specific surface area of only 21 m2/g and a low pore volume of 0.16 cm3/g. Upon doping with La and Ba, and heat-treating at 1100 °C for 4 h, the specific surface areas of the activated alumina samples obtained by the low-heat solid-phase precursor method and sol–gel methods were 109 and 119 m2/g, respectively. When heated at high temperatures, the percentage loss of the specific surface area of the activated alumina synthesised by the low-heat solid-phase precursor method was lower than that of the sample obtained by the sol–gel method, indicating that it can inhibit the crystal-phase transformation of alumina at high temperatures.

Efficient Preparation of Submicrometer Α‐alumina Powders by Calcining Carbon‐Covered Alumina

Effect of Pore Size Distribution of Carbon‐Covered Alumina on the Preparation of Submicrometer Α‐alumina Powders

Preparation of Fineα-Al_2O_3 Powders by Calcining Carbon-coveredγ-Al_2O_3 in Oxygen

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

Preparation of α-Al2O3 by low-temperature calcining γ-Al2O3 with α-phase seed in-situ obtained by ball milling

Lowering the synthesis temperature of α‐Al2O3 by increasing the content of pentacoordinate aluminum in the precursors

Preparation of Self-Healing Α-Al2o3 Films by Low Temperature Thermal Oxidation

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Preparation of Alumina Aerogel via Supercritical Method

PREPARATION AND CHARACTERIZATION OF ALUMINA NANOCRYSTALLINE POWDER BY COMPLEXING SOL-GEL METHOD

The activation mechanism of oxalic acid on γ-alumina and the formation of α-alumina

Synthesis of α-Al2O3 Nanopowders at Low Temperature from Aluminum Formate by Combustion Process

The formation mechanism and distribution of micro-aluminum oxide layer

Preparation of High Purity Alumina Ceramic Supports at Low Temperature

Self-propagating High-temperature Synthesis and Reaction Mechanism of Super-fine Particles of γ-LiAlO2

Self-propagating high-temperature synthesis and reaction mechanism of super-fine particles of gamma-LiAlO2

Reaction mechanism of micron-sized aluminum powders in O2 and CO2 gradually heated environment

Synthesis and characterization of activated alumina with high thermal stability by a low-heat solid-phase precursor method

Preparation And Characterization Of Gamma-Al2o3 By Polyaluminum Chloride With High Al-13 Content

The study of combustion synthesis of fine-particle γ-lithium aluminate

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy