Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. In this study, a novel TCU control structure and algorithms including also dynamic model of the transmission will perform the gear shifting of automatic transmissions used in tracked military vehicles are designed. In case of inherent wear of the clutches, the clutch parameters are estimated by means of an adaptation algorithm that uses only the information from the transmission input and output speed sensors. These estimated clutch parameters are used in clutch torque calculation is utilized by control algorithms. For the clutch speed control in the inertia phase, a PID control structure with a negative feedforward term that cancels the nonlinearities of the system is proposed. The feedforward term utilizes the estimated wear clutch coefficients in the calculation of friction coefficients. The parameters of the PID controller are optimized by a genetic algorithm. The designed all structure are firstly tested on a MATLAB/Simulink power train simulation model, and then tested using a unique transmission on a transmission dynamometer test bench to examine its suitability for real transmission scenarios. The performances of proposed PID control and a backstepping nonlinear controller that we constructed for the tracked vehicles are compared with and without clutch wear. Maximum tracking error is decreased by 98% with proposed adaptive PID control structure with nonlinear feedforward term compare to backstepping controller. In the case of clutch wear, the back-stepping control exists in the literature has been found to result in oscillation. By updating the estimated friction coefficient from adaptation algorithm, in the backstepping controller, it is concluded that these oscillations can be eliminated. Additionally, on-off solenoid valves, are widely used, are known to cause torque interruptions and jerks during gear shifting. It has been observed the control structure presented in this study reduced the jerks by one quarter.

Adaptive Clutch Engaging Process Control for Automatic Mechanical Transmission

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Analysis and Modeling for Electro-pneumatic AMT System

Study on the control law of automated mechanical transmission clutch

Analysis of Clutch Engagement Judder and Its Influence Factors

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

Single neuron adaptive PID control for hydro-viscous drive clutch

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Hierarchical Control of Starting Process for Wet Dual Clutch Transmission Based on Direct-Drive Pump-Controlled Hydraulic Actuator

Multi-state control strategy of starting for a wet friction clutch via a fuzzy logic algorithm

Wet Dual Clutch Launching Adaptive Control Considering Service Time

Engagement Control of Automated Clutch for Vehicle Launching Considering the Instantaneous Changes of Driver's Intention

Adaptive torque control of wet dual clutch based on dynamic friction coefficient estimation

Dynamic modeling, clutch parameter adaptation, and control of automatic transmission for tracked vehicles

Control of Automatic Diaphragm Clutch Engagement

Automatic Clutch Control Based on Estimation of Resistance Torque for AMT

Coordinated Clutch Slip Control for the Engine Start of Vehicles with P2-hybrid Automatic Transmissions

Research on shifting process control of automatic transmission

Analysis on the Engaging Process of Vehicle Clutch

An Analysis on the Evaluation Metrics of Control Quality for Vehicles with Dual Clutch Transmission

Robust engine slipping start control of hybrid electric vehicles with uncertainty in clutch slipping torque and change in driver demand torque