Abstract:High efficiency and wide stability at variable speeds are equally important to the design and operation of multistage axial flow compressors. However, published research works on three-dimensional design optimization of compressors are so far mainly limited to a single blade row or stage at design speed due to the curse of dimensionality. Moreover, optimization of variable inlet guide vanes (IGV)/stators for off-design operations is carried out by using a rapid but low-fidelity prediction tool and is generally independent of design optimization of blade geometry. To tackle these issues, a three-dimensional holistic design and adjustment optimization method is developed in which both three-dimensional blade geometry and variable IGV/stators are optimized simultaneously for better efficiency and stability at design and off-design conditions. Metamodel-interpreted data mining method and adaptive infilling strategy are used respectively to enhance the capability of the metamodeling and optimization. The developed method is then applied to a modern highly loaded 3.5-stage transonic axial flow compressor at both design and part-design speeds. The results show that the stall margin is extended from 8.23% to 19.65% at 70% design speed while peak efficiency is slightly improved at design speed. The flow mechanisms responsible for the efficiency enhancement at design speed are mainly associated with the reduced total pressure loss in stators as well as inter- and intra-stage loading redistribution. The stability enhancement at 70% design speed is mainly achieved by loading the front blade rows while unloading the limiting rear blade row through variable IGV/stators adjustment. The developed holistic design and adjustment optimization method with the aid of metamodel-interpreted data mining is of great application value for the design and adjustment of advanced multistage axial flow compressors.

Characteristic Estimation Method of Variable Geometry Multistage Axial-flow Compressors

An Average Stage Characteristics Generation Method of Multistage Axial Flow Compressors

Analytic Method for Computing Axial-flow Compressor and Turbine Characteristics

A throughflow-based optimization method for multi-stage axial compressor

Extrapolation of Performance Curves of Compressors Based on Averaged Infinitesimal Stage Characteristics

Performance Calculation of Axial Flow Compressor with Generalized Stage Characteristics

Calculation of the Overall Aerodynamic Performance of Multi-Stage Axial-Flow Compressor

An axisymmetric characteristic model for enhancing the prediction of centrifugal compressor characteristics

Optimization of Three-Dimensional Blade and Variable Stators for Efficiency and Stability Enhancement of Multistage Axial Flow Compressor at Variable Speeds

A Characteristic-Based 1D Axial Compressor Model for Stall and Surge Simulations

Geometric Parametric Modeling and Pressurization Characteristics Analysis of a Multistage Transonic Axial Compressor

An 11-Stage Axial Compressor Performance Simulation Considering the Change of Tip Clearance in Different Operating Conditions

Numerical Prediction of Multi-Stage Axial Compressor Performances

Investigation of Different Rotational Speed Characteristics of Multistage Axial Compressor in CAES System

Investigation on the Performance Prediction of Single-Stage Axial Compressor by Using Different Turbulence Models

Analysis on Two Model Stages of High Specific Speed Centrifugal Compressor

Performance Analysis of Multistage Axial Compressor at Surge Conditions

Development of a Throughflow-Based Simulation Tool for Preliminary Compressor Design Considering Blade Geometry in Gas Turbine Engine

Efficient Performance Prediction of a One-and-half Stage Axial Compressor Based on a Streamline-Curvature Throughflow Method and Stage Characteristics

Design and Performance Analysis of a Supercritical CO2 Centrifugal Compressor With Variable Geometry

Three-Dimensional Aerodynamic Optimization Of A Multi-Stage Axial Compressor