Abstract:The National Synchrotron Radiation Laboratory is planning to build a 2.2 GeV diffraction-limited storage ring, the Hefei Advanced Light Facility (HALF), with a 6BA lattice structure and a large number of longitudinal gradient bends (LGBs). In order to increase the radiated photon energy to the hard X-ray band and to reduce the natural emittance, a superconducting longitudinal gradient bend (SLGB) magnet is planned to be used on HALF in the future, which requires a magnetic field integral of 0.40 T·m over a length of 0.46 m and a peak field of about 5 T. A SLGB has many structural parameters, such as the geometric parameters of the superconducting coils and the thickness of the yoke, etc. Their influence on the magnetic field distribution has been studied, although the computation of the 3D magnet model is very slow. Considering the longitudinal field variation, the vertical gap limitation, the field homogeneity requirement and the critical current of the superconducting wire, a method is developed to simplify the 3D magnet simulation by a corresponding 2D model, so that the longitudinal magnetic field profile of a 3D model can be approximately calculated in a 2D model with faster speed. Due to the faster calculation speed of 2D models, a Mathematica-based optimization program is developed and relatively good structural parameters for the HALF SLGB are found by the program. The simulation results show that the physical design requirements can be well met. The electromagnetic design for the HALF SLGB magnet is based on the current J C level of NbTi superconductor due to its excellent mechanical performance.

Structural analysis of CR superconducting dipole magnet in FAIR project

Finite Element Analysis of Gradient Z-Coil Induced Eddy Currents in a Permanent MRI Magnet

Structural analysis of superconducting dipole prototype for HIAF

Coupling Nonlinear Dynamic Finite Element Model of Giant Magnetostrictive Actuator

Structural design and test of superconducting magnet coil for the cooling storage ring external-target experiment

Electromagnetic, stress and thermal analysis of the Superconducting Magnet

Structural Design of DC Magnet for Super-X Test Facility

Stress Analysis of a 7 T Actively Shielded Superconducting Magnet for Animal MRI

Structural optimization design and numerical analysis of in-vessel magnetic compression coils

Analysis of magnetic field and levitation force of single magnet

Conceptual Mechanical Structure Analysis of A 16 T Canted Cosine Theta (CCT) Magnet

Mechanical Design, Assembly and Strain Measurement Results of a 13-T Superconducting Dipole Magnet

3-D Analytical Model of Armature Reaction Field Calculation for Ironless Axial Flux Permanent Maanet Motor

Structure parametric optimization and mechanical analysis of the MSe1 septum magnet

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet

AC loss and thermal analysis of a curved DCT super-conducting magnet for carbon ion therapy

Mechanical performance evaluation of the CFETR central solenoid model coil design

Magneto-Mechanical Coupling Analysis of a Superconducting Solenoid Using FEM With Different Approaches

Analyze of Magnetic Structure's Characteristics of MR Fluid Damper

Efficient multiscale investigation of mechanical behavior in Nb3Sn superconducting accelerator magnet based on self-consistent clustering analysis

Electromagnetic Design Study of a Superconducting Longitudinal Gradient Bend Magnet Based on the HALF Storage Ring