Abstract:The indoor parameters are generally non-uniform distributed. Consequently, it is important to study the space cooling/heating load oriented to local requirements. Though the influence of indoor set point, heat sources, and ambient temperature of convective thermal boundary on cooling/heating load has been investigated in the uniform environment in previous research, the influence of these factors, particularly the convective heat gain/loss through a building envelope, on cooling/heating load of non-uniform environment has not yet been investigated. Therefore, based on the explicit expression of indoor temperature under the convective boundary condition, the expression of space cooling/heating load with convective heat transfer from the building envelope is derived and compared through case studies. The results can be summarized as follows. (1) The convective heat transferred through the building envelope is significantly related to the airflow patterns: the heating load in the case with ceiling supply air, where the supply air has a smaller contribution to the local zone, is 24% higher than that in the case with bottom supply air. (2) The degree of influence from each thermal boundary to the local zone of space cooling cases is close to that of a uniform environment, while the influence of each factor, particularly that of supply air, is non-uniformly distributed in space heating. (3) It is possible to enhance the influence of supply air and heat source with a reasonable airflow pattern to reduce the space heating load. In general, the findings of this study can be used to guide the energy savings of rooms with non-uniform environments for space cooling/heating.

Effect of Heat Emitted by Air Conditioner on Cooling Loads from Heat Conduction through Envelope and from Outdoor Air

Anti-insulation Behavior for Exterior Wall External Insulation on Residential Buildings in Hot Summer and Cold Winter Zone

The influence of heat transmission coefficient of office building on air-conditioning load

Moderating AC Usage Can Reduce Thermal Disparity between Indoor and Outdoor Environments

Temperature Field Simulation of Building Envelopes

Evaluation Model for Coupled Urban Local Climate and Buildings

Numerical Simulation of Thermal Environment for Outdoor Units at Building Re-Entrant

Study On The Impact Of Buildings On The Outdoor Thermal Environment Based On A Coupled Simulation Of Convection, Radiation, And Conduction

The effect of air-conditioner operation modes on the energy-saving capacity of external wall insulation in residential buildings

Influence of Air-Conditioning Intermittent Operation on the Cooling Load from Opaque Envelopes in Residences

Effect of Outdoor Meteorological Parameters on Partial Itemized Cooling and Heating Load of Building

Evaluation of Coupled Outdoor and Indoor Thermal Comfort Environment and Anthropogenic Heat

Comparison of space cooling/heating load under non-uniform indoor environment with convective heat gain/loss from envelope

A study on heat transfer load in large space buildings with stratified air-conditioning systems based on building energy modeling: Model validation and load analysis

Influence Of Sensible Cooling Load On Indoor Air Distribution In An Office Room With Ceiling Cooling And Mixing Ventilation

Numerical Simulation and Optimal Design of Micro-Climate of Shelter Parts of Air Conditioning Outer Unit

Simulation of energy consumption of air conditioning system for an office building

Effectiveness of the thermal mass of external walls on residential buildings for part-time part-space heating and cooling using the state-space method

Influence of environment on air conditioner performance

Direct Relationship Between the System Cooling Load and Indoor Heat Gain in a Non-Uniform Indoor Environment

Analysis of Heat Rejection from an Actual Large-Scale Air-conditioned Office Building by Field Measurements and Numerical Simulations