Abstract:This paper describes the design of a new magnetic flux leakage (MFL) inspection tool that performs an inline inspection to detect and characterize both metal loss and mechanical damage defects. An inspection tool that couples mechanical damage assessment as part of a routine corrosion inspection is expected to have considerably better prospects for application in the pipeline industry than a tool that complicates existing procedures. The design is based on study results that show it is feasible to detect and assess mechanical damage by applying a low magnetic field level in addition to the high magnetic field employed by most inspection tools. Nearly all commercially available MFL tools use high magnetic fields to detect and size metal loss such as corrosion. A lower field than is commonly applied for detecting metal loss is appropriate for detecting mechanical damage, such as the metallurgical changes caused by impacts from excavation equipment. The lower field is needed to counter the saturation effect of the high magnetic field, which masks and diminishes important components of the signal associated with mechanical damage. Finite element modeling was used in the design effort and the results have shown that a single magnetizer with three poles is the most effective design. Furthermore, it was found that for the three-pole system the high magnetization pole must be in the center, which was an unexpected result. The three-pole design has mechanical advantages, including a magnetic null in the backing bar, which enables installation of a pivot point for articulation of the tool through bends and restrictions. This design was prototyped and tested at Battelle’s Pipeline Simulation Facility (West Jefferson, OH). The signals were nearly identical to results acquired with a single magnetizer reconfigured between tests to attain the appropriate high and low field levels.

Design of Turning Device for Tube during Hi-speed Flux Leakage Flaw Detection

Development of Torsion Experiment Device for Thin- Wall Tube with Open Section

Design and Finite Element Analysis of High Efficiency and High Precision Centering Device for Ship Pipe Welding

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Design and Development of Turn Insulation Automatic Wrapping System for CRAFT TF

A new tube forging process for manufacturing hollow parts with inner flange at an arbitrary location

Digital Radiographic Testing System Design for Tube and Tube-Sheet Weld

Design and application of portable eddy current inspection device for thimble tubes of nuclear power plant

Numerical Simulation on Magnetic Flux Leakage Testing of the Steel Cable at Different Speed Title

Optimal design of iron-cored coil sensor in magnetic flux leakage detection of thick-walled steel pipe

Failure Analysis on Unexpected Fracture of the Hydraulic Expansion Mandrel for Tube to Tubesheet Expanding in the Steam Generator of Nuclear Power Plant

Design of an Automatic Control System for Magnetic Controlled Narrow-Gap TIG Arc Welding of Thick Plates

Combining ultrasonic guided wave and low-frequency electromagnetic technology for defect detection in high-temperature Cr–Ni alloy furnace tubes

The Design of a Mechanical Damage Inspection Tool Using Dual Field Magnetic Flux Leakage Technology

Design of Automatic Flux Feeder for Continuous Casting Mould of Fixed Size Plate Blank

Formation criterion of fissure defects in the inner wall of the radial forged steel tube

Research on thinning spinning flaring for thin-walled tube

Automatic Ultrasonic Flaw Detecting System for Locomotive Axles

Approach Based on Response-Surface Method to Optimize Lining of Dies Used in 3D Free-Bending Forming Technology

Design and experimental study of electromagnetic ultrasonic single-mode guided wave transducer for small-diameter stainless steel tubes

Investigation of the Bright and Dark Line on the Inner Wall of a Thin-Walled Copper Tube by Drawing with a Floating Plug