Abstract:Shock tube ignition delay times and species time history measurements for Primary Reference Fuels (PRFs) such as normal heptane provide targets for the validation of combustion models, which in turn are used to develop more fuel-efficient engines that have smaller environmental footprints. However, a review of the literature has revealed that most of the shock tube ignition delay time and species measurement data for normal heptane have been obtained at elevated pressures, rather than at relatively low pressures where many other important experimental techniques such as jet-stirred reactors and flow reactors can provide corroborating results. One central problem preventing previous shock tube studies from examining first-stage ignition at these lower pressures was that ignition times were too long under these conditions to be measured within the available shock tube test times. To address this issue, recent advances in shock tube techniques for achieving long uniform test times have been applied in order to measure low-pressure first-stage ignition times of normal heptane together with normal heptane fuel time-history records at times up to about 30 ms. These measurements were performed in the Negative Temperature Coefficient (NTC) region (T = 664 - 792 K) in lean mixtures (21%O-2/Ar, equivalence ratio phi = 0.5) at pressures of roughly P = 3.5 atm using both the conventional and Constrained Reaction Volume (CRV) shock tube filling strategies. The data have been used to evaluate the performance of several combustion models, have been compared with other higher-pressure shock tube first-stage ignition times in n-heptane/20-21%O-2 mixtures found in the literature, and have been fit using a two-zone Arrhenius model for first-stage ignition delay times. The results showed that some combustion models yield ignition delay time predictions that differ from the experimental results by as much as an order of magnitude, that under these conditions n-heptane first-stage ignition times scale by roughly P-0.71 but are insensitive to phi, and that the fraction of fuel remaining after first-stage ignition increases with increasing initial experimental temperature. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Shock Tube Study of N-Decane Ignition at Low Pressures

n-Dodecane oxidation at high-pressures: Measurements of ignition delay times and OH concentration time-histories

Shock Tube Study of Methylcyclohexane Ignition over a Wide Range of Pressure and Temperature

Shock Tube Study on Auto-Ignition Characteristics of Kerosene/air Mixtures

Experimental Measurement of Ignition Delay Times of Thermally Cracked N-Decane in a Shock Tube

Shock Tube Study of Ignition-Delay Measurements and Kinetic Mechanism Research for Syngas

Ignition Delay Times of Ethane under O2/CO2 Atmosphere at Different Pressures by Shock Tube and Simulation Methods

Constrained reaction volume shock tube study of n -heptane oxidation: Ignition delay times and time-histories of multiple species and temperature

Shock tube ignition delay time measurements in propane/O2/argon mixtures at near-constant-volume conditions

Study on Ignition Delay of Kerosene Aerosol in Shock Tube

Shock tube and modeling study of ignition delay times of propane under O2/CO2/Ar atmosphere

Ignition Delay Time Measurements of Normal Alkanes and Simple Oxygenates

Shock Tube Study on Auto-ignition Delay of Kerosene Aerosol and its Cracked Mixture

Shock Tube Study of Normal Heptane First-Stage Ignition Near 3.5 Atm

Shock Tube Measurement of Ethylene Ignition Delay Time and Molecular Collision Theory Analysis

Time-resolved CO2 Concentration and Ignition Delay Time Measurements in the Combustion Processes of N-Butane/hydrogen Mixtures

An Experimental Investigation of Ethylene/o2/diluent Mixtures: Laminar Flame Speeds with Preheat and Ignition Delays at High Pressures

Ignition Delay-Time Behind Reflected Shock Waves of Small Hydrocarbons–nitrous Oxide(–oxygen) Mixtures

Ignition Characteristics of Dual-Fuel Methane-N-hexane-oxygen-diluent Mixtures in a Rapid Compression Machine and a Shock Tube

Effect of nitrogen dioxide addition on ethane auto-ignition at different pressures and equivalence ratios: Experiments and chemical kinetic modeling

Experimental and modeling study on ignition delays of lean mixtures of methane, hydrogen, oxygen, and argon at elevated pressures